OBD-II trouble code · Powertrain (engine and transmission)

P0606 ECM/PCM Processor Fault

The engine computer's self-check found a problem with its own processor. Sometimes it's a wiring, voltage or software issue, but it can mean the computer itself is failing.

SeverityHigh
Safe to drive?Not recommended beyond getting it to a shop, because the engine may stall, lose power or go into limp mode without warning.

My main brain says something's off with its own processor, which can make me lose power without warning. Please get me checked soon and don't plan any long trips.

— FRED, speaking as your car

What P0606 means

Modern PCMs often use more than one processor that cross-check each other. P0606 sets when the module's internal diagnostics detect a processor fault or disagreement, which can be triggered by internal failure, corrupted software, or outside factors like low voltage, poor grounds, or a faulty input such as an electronic throttle circuit. On many vehicles it is linked to electronic throttle control and may cause reduced power mode. Software updates exist for some vehicles, and diagnosis varies by make.

Common symptoms

  • Check engine light on
  • Reduced power or limp mode
  • Stalling or no-start
  • Throttle not responding properly
  • Transmission shifting problems

Likely causes (most likely first)

  1. Internal PCM failure
  2. Corrupted or outdated PCM software
  3. Low system voltage or poor grounds
  4. Water or heat damage to the PCM
  5. Faulty sensor or actuator circuit affecting the processor check (such as electronic throttle)

What you can check yourself

  1. Test battery and charging system voltage
  2. Clean and tighten battery terminals and check main grounds
  3. Scan for other codes, especially throttle and voltage codes
  4. Inspect the PCM and connector for water, corrosion or damage
  5. Ask a dealer or shop whether a software update applies to your vehicle

FRED reads freeze frame and live data, so you can see what the engine was doing when P0606 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair voltage or ground issue$100–$400
Reflash/update PCM software$100–$300
Repair related sensor/throttle circuit$150–$600
Replace and program PCM$700–$2,000

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0606 FAQ

No. Voltage, grounds, software and related circuits should be checked first. Replacement is only needed if the module itself has failed.
When the computer can't trust its processor checks, it often limits power to keep the vehicle under control and protect the engine.

Related codes