OBD-II trouble code · Powertrain (engine and transmission)
P0603 Internal Control Module Keep Alive Memory (KAM) Error
The engine computer lost or couldn't verify the learned information it keeps in memory when the car is off. This is often caused by battery power interruptions, but can also be a module fault.
I forgot some of what I'd learned about how I like to run, probably because my power got interrupted. If it keeps happening, let's check my battery connections and memory power.
— FRED, speaking as your car
What P0603 means
The PCM stores learned values, such as fuel trims and idle settings, in keep alive memory that stays powered by the battery when the ignition is off. P0603 sets when that memory fails a check, typically because constant battery power was interrupted or the module has an internal fault. A recently disconnected or dead battery, corroded terminals, a blown memory fuse, or a parasitic drain can cause it. Some vehicles clear it after a battery disconnect; repeat occurrences need diagnosis.
Common symptoms
- Check engine light on
- Rough idle or hesitation while the computer relearns
- Code returns after every restart in some cases
- Engine may stall or not start in rarer cases
- Radio presets or clock may also reset
Likely causes (most likely first)
- Recent battery disconnection or dead battery
- Loose or corroded battery terminals
- Blown fuse feeding constant power to the PCM
- Poor ground connection
- Internal PCM failure
What you can check yourself
- Ask whether the battery was recently disconnected or died; if so, clear the code and see if it returns
- Clean and tighten battery terminals
- Test the battery and charging system
- Check the PCM memory or constant power fuse with a test light or multimeter
- Inspect PCM grounds and connector
FRED reads freeze frame and live data, so you can see what the engine was doing when P0603 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Clean/replace battery terminals | $50–$200 |
| Replace battery | $150–$350 |
| Repair PCM power feed/ground or fuse | $100–$350 |
| Replace and program PCM | $700–$2,000 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.