OBD-II trouble code · Powertrain (engine and transmission)

P0601 Internal Control Module Memory Check Sum Error

The engine computer ran a self-test on its own memory and found the data didn't match what it expected. This usually means the computer's software or memory is corrupted.

SeverityHigh
Safe to drive?Avoid driving if the engine runs poorly, stalls or won't start reliably, and get it to a shop soon, because a corrupted engine computer can fail without warning.

I checked my own memory and something doesn't add up, so my software may be scrambled. A shop can often reload it before anything gets replaced.

— FRED, speaking as your car

What P0601 means

Control modules regularly calculate a checksum of their stored programming and compare it with a known value. P0601 sets when that check fails, which suggests the stored software or calibration is corrupted. Interrupted or incorrect reprogramming, voltage spikes, water damage or internal failure can cause it. Some cases are resolved by reflashing the module with the correct software; others need a replacement module programmed to the vehicle. Procedures vary by make.

Common symptoms

  • Check engine light on
  • Engine may not start or may stall
  • Poor running, misfire-like behavior or limp mode
  • Transmission shifting issues
  • Possible no symptoms other than the light

Likely causes (most likely first)

  1. Corrupted PCM software or calibration
  2. Interrupted or failed reprogramming
  3. Internal PCM memory failure
  4. Voltage spikes or poor battery connections
  5. Water or heat damage to the module

What you can check yourself

  1. Test battery and charging system to rule out voltage problems
  2. Check that battery terminals and grounds are clean and tight
  3. Note any recent battery work, jump starts or programming
  4. Inspect the PCM and its connector for water, corrosion or damage
  5. Clear the code once to see if it returns immediately, then let a shop with factory-level tools check for software updates

FRED reads freeze frame and live data, so you can see what the engine was doing when P0601 set, before you buy any parts.

Typical repair costs

RepairTypical range
Reflash/reprogram PCM$100–$300
Replace and program PCM$700–$2,000
Repair voltage/ground issues$100–$400

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0601 FAQ

Sometimes. If the memory itself is OK, reprogramming with the correct software can resolve it. If the memory hardware has failed, the module needs replacing.
Often a used module has to be programmed to your vehicle, including anti-theft data, so check with a shop before buying one.

Related codes