OBD-II trouble code · Powertrain (engine and transmission)
P0112 Intake Air Temperature Circuit Low Input
Your intake air temperature sensor's signal is too low, which the computer reads as extremely hot air. This is usually a shorted wire or bad sensor.
My air temperature sensor says it's scorching in here, but I don't think it is. Probably a shorted wire or tired sensor.
— FRED, speaking as your car
What P0112 means
The IAT sensor's voltage drops as temperature rises. P0112 sets when the signal stays below its minimum, which the computer interprets as an implausibly high air temperature. This often means the signal wire is shorted to ground or the sensor has failed internally. Some vehicles have the IAT inside the MAF. Thresholds vary by make.
Common symptoms
- Check-engine light on
- Live data shows very high intake air temperature
- Possible hard cold starts
- Slight hesitation
- Reduced fuel economy
- Often no noticeable symptoms
Likely causes (most likely first)
- Signal wire shorted to ground
- Faulty IAT sensor
- Damaged connector
- Faulty MAF with integrated IAT
- Chafed wiring harness
- Engine computer fault (rare)
What you can check yourself
- View live IAT; a reading far above ambient on a cold engine confirms the problem
- Inspect wiring for chafing against metal
- Unplug the sensor and watch live data; reading should drop to a very cold value if the wiring is good
- Measure sensor resistance against specifications
- Replace the sensor if wiring checks out
FRED reads freeze frame and live data, so you can see what the engine was doing when P0112 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace IAT sensor | $50–$200 |
| Repair shorted wiring | $75–$250 |
| Replace MAF with integrated IAT | $150–$450 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.