OBD-II trouble code · Powertrain (engine and transmission)

P0102 Mass or Volume Air Flow Circuit Low Input

Your airflow sensor's signal is lower than it should be, as if almost no air were entering the engine. This is usually a wiring, connector, or sensor problem.

SeverityModerate
Safe to drive?Often drivable carefully, but the engine may stall, hesitate, or go into reduced-power mode; get it fixed soon and avoid highways if it stalls.

My airflow sensor is barely whispering to me, like no air is coming in at all. Check its plug and wires first!

— FRED, speaking as your car

What P0102 means

The engine computer monitors the MAF signal voltage or frequency. P0102 sets when the signal stays below its expected minimum for a set time with the engine running. This often indicates an open circuit, poor connection, short to ground, missing power supply, or a failed sensor. Whether the signal is voltage or frequency based, and the exact thresholds, vary by make.

Common symptoms

  • Check-engine light on
  • Stalling, especially after starting
  • Hesitation or poor power
  • Rough idle
  • Hard starting
  • Poor fuel economy

Likely causes (most likely first)

  1. Unplugged, loose, or corroded MAF connector
  2. Open or shorted MAF signal wire
  3. Blown fuse or missing sensor power
  4. Faulty MAF sensor
  5. Poor ground connection
  6. Large intake leak after the MAF (some vehicles)

What you can check yourself

  1. Confirm the MAF connector is fully seated and locked
  2. Inspect pins for corrosion and wires for damage
  3. Check relevant fuses
  4. View live MAF reading at idle; a value near zero confirms a low signal
  5. With a multimeter, check for power and ground at the connector per a wiring diagram
  6. Clean the sensor and retest

FRED reads freeze frame and live data, so you can see what the engine was doing when P0102 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair connector or wiring$100–$300
Replace blown fuse and find cause$20–$200
Replace MAF sensor$150–$450
Clean MAF sensor$10–$100

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0102 FAQ

Heavy contamination can lower readings, but P0102 more often points to an electrical problem like a bad connection or open wire.
Some vehicles reduce power or use a backup fuel calculation when the MAF signal is lost. Behavior varies by make.

Related codes