OBD-II trouble code · Powertrain (engine and transmission)

P0117 Engine Coolant Temperature Circuit Low Input

Your engine temperature sensor's signal is too low, which the computer reads as an extremely hot engine. This is usually a shorted wire or bad sensor, but always confirm the engine isn't actually overheating.

SeverityModerate
Safe to drive?If your gauge shows hot, you see steam, or the engine is actually overheating, stop safely and see a pro; if the engine is confirmed normal, drive cautiously only to a repair shop.

My temperature sensor says I'm blazing hot. If I'm not actually overheating, it's likely a wiring short, but please check before driving far.

— FRED, speaking as your car

What P0117 means

The ECT sensor's voltage drops as temperature rises. P0117 sets when the signal stays below its minimum, which the computer interprets as extremely high coolant temperature. Common causes are a signal wire shorted to ground or a failed sensor. Because a real overheat looks similar on the gauge, confirm actual engine temperature. Thresholds vary by make.

Common symptoms

  • Check-engine light on
  • Temperature gauge reading high or pegged
  • Cooling fans running constantly
  • Hard starting when cold
  • Lean running or hesitation when cold
  • Poor fuel economy

Likely causes (most likely first)

  1. Signal wire shorted to ground
  2. Faulty ECT sensor
  3. Damaged connector
  4. Chafed wiring harness
  5. Engine computer fault (rare)
  6. Actual engine overheating (verify)

What you can check yourself

  1. Check for real overheating: steam, boiling coolant, hot smell, or temperature warning
  2. View live ECT on a cold engine; it should be near ambient
  3. Unplug the sensor and watch live data; reading should jump to very cold if the wiring is good
  4. Inspect wiring for chafing
  5. Measure sensor resistance against specifications
  6. Replace sensor if wiring tests good

FRED reads freeze frame and live data, so you can see what the engine was doing when P0117 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace ECT sensor$80–$250
Repair shorted wiring$100–$300
Diagnostic testing$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0117 FAQ

Look for steam, coolant boiling over, a hot smell, or a temperature warning light. If any are present, stop and see a pro.
The sensor's resistance drops as it heats up, so a very low signal looks like very high temperature.

Related codes