OBD-II trouble code · Powertrain (engine and transmission)

P0107 Manifold Absolute Pressure/Barometric Pressure Circuit Low Input

Your manifold pressure sensor's signal is lower than normal, often from a wiring or connector problem. The engine may run poorly as a result.

SeverityModerate
Safe to drive?Often drivable carefully, but the engine may hesitate, stall, or run rich or lean; get it repaired soon.

My manifold pressure sensor's voice is too quiet for me to hear clearly. Let's check its wiring and plug.

— FRED, speaking as your car

What P0107 means

P0107 sets when the MAP sensor signal voltage stays below the minimum expected value. A low signal usually indicates an open signal circuit, lost 5-volt reference, short to ground, or a failed sensor. Because the 5-volt reference is often shared with other sensors, multiple sensor codes together suggest a shared circuit problem. Details vary by make.

Common symptoms

  • Check-engine light on
  • Rough idle
  • Hesitation or stalling
  • Poor fuel economy
  • Hard starting
  • Possible reduced power

Likely causes (most likely first)

  1. Damaged or disconnected MAP connector
  2. Open or shorted signal wire
  3. Loss of 5-volt reference voltage
  4. Faulty MAP sensor
  5. Shorted sensor on the shared 5-volt circuit
  6. Engine computer fault (rare)

What you can check yourself

  1. Inspect the MAP connector and wiring for damage or corrosion
  2. Check for other sensor codes that share the 5-volt reference
  3. View the live MAP reading with key on, engine off; it should be near barometric pressure
  4. Use a multimeter to verify roughly 5 volts reference at the connector per a wiring diagram
  5. Wiggle-test wiring while watching live data
  6. Replace the sensor if wiring tests good

FRED reads freeze frame and live data, so you can see what the engine was doing when P0107 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair wiring or connector$100–$300
Replace MAP sensor$100–$350
Diagnose shared 5-volt circuit$100–$300

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0107 FAQ

Many sensors share a 5-volt reference. If one shorts, it can pull down the supply and trigger codes for several sensors.
Yes, with a multimeter and a wiring diagram you can check reference, ground, and signal voltage.

Related codes