OBD-II trouble code · Powertrain (engine and transmission)

P0106 Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance

The sensor that measures pressure (vacuum) inside your intake manifold is giving readings that don't match what the engine is doing. Vacuum leaks and bad hoses are common causes.

SeverityModerate
Safe to drive?Usually drivable short-term, but the engine may run rough or use more fuel; get it diagnosed soon.

My manifold pressure readings aren't lining up with how hard I'm working. Check my vacuum hoses first, that's a cheap fix.

— FRED, speaking as your car

What P0106 means

The MAP sensor measures intake manifold pressure, which the engine computer uses for fuel and timing calculations. P0106 sets when the MAP reading is electrically valid but implausible, such as not changing as expected with throttle or rpm, or disagreeing with barometric pressure at key-on. Vacuum leaks, a cracked sensor hose, or a sluggish sensor are common. Some vehicles combine MAP and barometric sensing, and logic varies by make.

Common symptoms

  • Check-engine light on
  • Rough idle
  • Hesitation or poor acceleration
  • Poor fuel economy
  • Rich or lean running
  • Possible hard starting

Likely causes (most likely first)

  1. Cracked or disconnected MAP sensor vacuum hose
  2. Vacuum leak in the intake
  3. Faulty MAP sensor
  4. Clogged MAP sensor port
  5. Poor electrical connection
  6. Engine mechanical issue causing low vacuum (on some vehicles)

What you can check yourself

  1. Inspect the MAP sensor hose (if equipped) for cracks or disconnection
  2. Check the sensor port for carbon buildup
  3. With key on and engine off, compare MAP reading to local barometric pressure; they should be close
  4. At warm idle, MAP should drop well below barometric pressure (high vacuum)
  5. Inspect intake hoses for vacuum leaks
  6. Check the connector for corrosion

FRED reads freeze frame and live data, so you can see what the engine was doing when P0106 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace MAP sensor hose$20–$100
Replace MAP sensor$100–$350
Repair vacuum leak$50–$400
Repair wiring or connector$100–$300

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0106 FAQ

The MAF measures air flowing in; the MAP measures pressure inside the manifold. Some vehicles use one, some use both.
Yes. Mechanical problems that reduce vacuum can confuse the computer, so a vacuum gauge test can be helpful.

Related codes