OBD-II trouble code · Powertrain (engine and transmission)

P0108 Manifold Absolute Pressure/Barometric Pressure Circuit High Input

Your manifold pressure sensor's signal is higher than normal, as if there were no engine vacuum. This often comes from a vacuum hose, wiring, or sensor problem.

SeverityModerate
Safe to drive?Usually drivable carefully, but expect rich running, rough idle, or poor economy; have it repaired soon.

My manifold pressure sensor says I have no vacuum at all, which doesn't seem right. Check its hose and ground wire!

— FRED, speaking as your car

What P0108 means

P0108 sets when the MAP signal stays above the maximum expected value. A high reading can happen if the sensor loses its vacuum connection, if the signal wire shorts to voltage, if the sensor ground is lost, or if the sensor fails. Severe engine vacuum problems can also contribute on some vehicles. Details vary by make.

Common symptoms

  • Check-engine light on
  • Rough idle
  • Poor fuel economy
  • Black smoke or fuel smell
  • Hesitation
  • Hard starting

Likely causes (most likely first)

  1. Disconnected or cracked MAP vacuum hose
  2. Lost ground at the MAP sensor
  3. Signal wire shorted to voltage
  4. Faulty MAP sensor
  5. Clogged sensor port
  6. Low engine vacuum from mechanical issues

What you can check yourself

  1. Inspect the MAP vacuum hose and port
  2. Check the connector and wiring
  3. Compare MAP reading at warm idle with barometric pressure; it should be much lower at idle
  4. Check sensor ground with a multimeter per a wiring diagram
  5. Clean the sensor port if carboned
  6. Replace the sensor if the circuit tests good

FRED reads freeze frame and live data, so you can see what the engine was doing when P0108 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace vacuum hose$20–$100
Repair ground or wiring$100–$300
Replace MAP sensor$100–$350

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0108 FAQ

Not directly, but the resulting rich mixture can foul plugs and stress the catalytic converter if ignored.
On turbocharged engines boost raises manifold pressure, and some vehicles use a separate boost sensor. Diagnosis differs, so check a service manual.

Related codes