OBD-II trouble code · Powertrain (engine and transmission)
P0122 Throttle/Pedal Position Sensor/Switch A Circuit Low Input
Your throttle or pedal position sensor's signal is too low, often from a wiring problem or failed sensor. The car may hesitate or go into reduced-power mode.
My throttle sensor signal has gone quiet, so I may limit power to keep us safe. Let's get its wiring checked.
— FRED, speaking as your car
What P0122 means
P0122 sets when the TPS A signal voltage stays below its minimum. Common causes are an open signal wire, lost 5-volt reference, short to ground, or a failed sensor. Because the 5-volt reference is often shared, other sensor codes may appear together. Details vary by make.
Common symptoms
- Check-engine light on
- Reduced-power mode
- Hesitation or no response to pedal
- Stalling
- Erratic idle
- Poor shifting
Likely causes (most likely first)
- Open or shorted signal wire
- Loss of 5-volt reference
- Faulty throttle position sensor
- Corroded or loose connector
- Faulty throttle body assembly
- Shorted sensor on shared reference circuit
What you can check yourself
- Inspect the throttle body connector and wiring
- Check for other sensor codes on the shared 5-volt reference
- View live TPS with key on; a very low or zero reading confirms
- Use a multimeter to check reference, ground, and signal per a wiring diagram
- Wiggle-test wiring while watching live data
- Replace sensor or throttle body if the circuit tests good
FRED reads freeze frame and live data, so you can see what the engine was doing when P0122 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Repair wiring or connector | $100–$300 |
| Replace throttle position sensor | $100–$300 |
| Replace electronic throttle body | $300–$900 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.