OBD-II trouble code · Powertrain (engine and transmission)
P0717 Input/Turbine Speed Sensor Circuit No Signal
The transmission computer is getting no signal at all from the input or turbine speed sensor. This often causes rough shifting or limp mode.
I'm hearing nothing from my input speed sensor, total silence. Usually that's a plug or wire, so let's check those first.
— FRED, speaking as your car
What P0717 means
P0717 sets when the TCM sees no pulses from the input or turbine speed sensor while other data shows the engine and vehicle are moving. It typically points to an open circuit, an unplugged or damaged connector, a dead sensor, or a broken wire, though an internal transmission issue that stops the reluctor from turning can also do it. Details vary by transmission design.
Common symptoms
- Transmission stuck in one gear
- Harsh or delayed shifts
- No torque converter lockup
- Possible speedometer problems
- Check engine light on
Likely causes (most likely first)
- Failed input/turbine speed sensor
- Unplugged, broken or corroded connector
- Open or shorted wiring
- Fluid contamination in the connector
- Internal transmission fault (less common)
- TCM fault (rare)
What you can check yourself
- Read the transmission module for related codes
- Inspect the sensor connector to make sure it's fully seated and not damaged
- Look for broken, chafed or melted wiring along the harness
- Check resistance of the sensor if it's a two-wire type, compared with spec
- Check transmission fluid level and condition
FRED reads freeze frame and live data, so you can see what the engine was doing when P0717 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Reconnect/repair connector or wiring | $75–$300 |
| Replace external input speed sensor | $150–$450 |
| Replace internal sensor | $400–$1,200 |
| Internal transmission repair (if mechanical cause) | $1,500–$5,000 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.