OBD-II trouble code · Powertrain (engine and transmission)

P0715 Input/Turbine Speed Sensor Circuit Malfunction

The transmission computer isn't getting a good signal from the sensor that measures how fast the transmission's input side is spinning. Without it, shifts can get harsh or the transmission may go into limp mode.

SeverityModerate
Safe to drive?Drive gently and only to get it diagnosed, because harsh shifts or limp mode can make merging and highway driving unsafe and can stress the transmission.

I can't tell how fast my transmission's input is spinning, so I'm shifting half-blind. Let's check that sensor before my gears get grumpy.

— FRED, speaking as your car

What P0715 means

The input or turbine speed sensor measures the rotation speed of the transmission input shaft or torque converter turbine. The TCM compares it with engine and output speed to control shift timing, line pressure and torque converter lockup. P0715 sets when that signal is missing, erratic, or out of range. Common causes are a failed sensor, wiring or connector damage, or metal debris on a magnetic sensor tip. Sensor location and whether it's internal or external vary by transmission.

Common symptoms

  • Harsh or erratic shifting
  • Transmission stuck in one gear (limp mode)
  • Speedometer issues on some vehicles
  • Torque converter not locking up
  • Check engine light on

Likely causes (most likely first)

  1. Failed input/turbine speed sensor
  2. Damaged or corroded sensor wiring or connector
  3. Metal debris on the sensor tip
  4. Low or contaminated transmission fluid
  5. Internal transmission problem affecting the reluctor
  6. TCM fault (less common)

What you can check yourself

  1. Read all transmission codes with a capable adapter and note related codes
  2. Check transmission fluid level and condition if your vehicle has a dipstick
  3. Locate the sensor (repair manual) and inspect its connector and wiring
  4. Remove an externally mounted sensor and clean any metal debris from the tip
  5. Measure sensor resistance against spec if it's a two-wire magnetic sensor

FRED reads freeze frame and live data, so you can see what the engine was doing when P0715 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair sensor wiring/connector$100–$350
Replace external input speed sensor$150–$450
Replace internal sensor (requires pan/valve body removal)$400–$1,200
Fluid and filter service$150–$400

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0715 FAQ

No. The input sensor measures the incoming side of the transmission; the output sensor (P0720) measures the side going to the wheels. The computer compares both.
Low or dirty fluid can contribute to erratic behavior, so checking fluid is a smart early step, but the code usually points to the sensor circuit.

Related codes