OBD-II trouble code · Powertrain (engine and transmission)

P0457 Evaporative Emission Control System Leak Detected (Fuel Cap Loose/Off)

The engine computer detected an EVAP system leak that it believes is caused by a loose or missing gas cap. Tightening or replacing the cap usually fixes it.

SeverityLow
Safe to drive?Safe to drive; tighten or replace the gas cap and the light should go off after the system retests. If you smell strong raw fuel or see fuel leaking, stop driving and have it inspected by a pro, because that is a fire risk.

Psst, I think my gas cap isn't on tight! Give it a twist until it clicks, and I'll clear my light after a few drives.

— FRED, speaking as your car

What P0457 means

The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. On many vehicles, the PCM runs a quick leak check after refueling. If the system cannot hold pressure or vacuum right after the fuel level rises, the PCM assumes the gas cap was left loose or off and sets this code. If the cap is fine, other leaks in the filler neck or EVAP system can also trigger it. Test strategies vary by make.

Common symptoms

  • Check engine light on
  • 'Check fuel cap' or 'Tighten gas cap' message on some vehicles
  • Possible fuel smell near the filler
  • Usually no change in how the car drives
  • Failed emissions inspection if not resolved

Likely causes (most likely first)

  1. Gas cap loose, not clicked, or left off
  2. Worn or cracked gas cap seal
  3. Wrong or poor-fitting replacement cap
  4. Dirty or damaged filler neck sealing surface
  5. Leak in filler neck or nearby EVAP hose
  6. Capless filler door seal not closing properly (on capless systems)

What you can check yourself

  1. Check that the gas cap is on and tighten it until it clicks
  2. Remove the cap and inspect the rubber seal for cracks, swelling, or debris
  3. Look at the filler neck lip for rust, dirt, or damage
  4. On capless systems, check that the flap closes fully and is not blocked by debris
  5. Replace the cap with the correct OEM-spec cap if it looks worn
  6. Drive normally for a few days so the system can retest and turn off the light

FRED reads freeze frame and live data, so you can see what the engine was doing when P0457 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace gas cap$15–$40
Clean or repair capless filler seal$50–$250
Smoke test if code returns$100–$200
Replace fuel filler neck$250–$600

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0457 FAQ

It usually takes several drive cycles, sometimes a few days, for the system to retest. You can also clear the code with your OBD-II adapter after tightening the cap.
Some do, but poorly fitting caps can keep causing leak codes. Use a cap that matches your vehicle's specification.

Related codes