OBD-II trouble code · Powertrain (engine and transmission)

P0442 Evaporative Emission Control System Leak Detected (Small Leak)

The engine computer detected a small leak in the fuel vapor (EVAP) system. A worn gas cap seal, a cracked hose, or a leaking valve are common causes.

SeverityLow
Safe to drive?Generally safe to drive because the engine still runs normally, but get it fixed to keep fuel vapors in and pass inspection. If you smell strong raw fuel or see fuel leaking, stop driving and have it inspected by a pro, because that is a fire risk.

I've sprung a small leak in my fuel-vapor system. It won't hurt how I run, but a gas cap check and a smoke test will find where my vapors are escaping.

— FRED, speaking as your car

What P0442 means

The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. To check for leaks, the PCM seals the system (closing the vent valve) and watches whether it holds vacuum or pressure, using the fuel tank pressure sensor; some vehicles use a separate leak-check pump or module instead. This code was set because the system lost vacuum or pressure at a rate that indicates a small leak, roughly the size of a pinhole to about a 1 mm (0.040-inch) opening on many vehicles. Leak sizes, test conditions, and test hardware vary by make.

Common symptoms

  • Check engine light on
  • Usually no change in how the car drives
  • Possible faint fuel smell, especially near the rear of the car
  • Possible 'check fuel cap' message on some vehicles
  • Failed emissions inspection

Likely causes (most likely first)

  1. Loose, worn, or wrong gas cap
  2. Cracked or brittle EVAP hose
  3. Leaking purge or vent valve
  4. Leaking fuel filler neck or its seal
  5. Cracked charcoal canister
  6. Leaking fuel tank sending unit seal
  7. Faulty fuel tank pressure sensor

What you can check yourself

  1. Check the gas cap: make sure it is the correct type, inspect the rubber seal for cracks, and tighten until it clicks
  2. Clear the code and drive normally for several days to allow the EVAP monitor to rerun
  3. Visually inspect the filler neck and any EVAP hoses you can safely see for cracks, rust, or disconnection
  4. Check the purge and vent valve areas for disconnected or damaged hoses
  5. Look up whether your vehicle uses a leak-detection pump or module and check its hoses and connector
  6. If the code returns, have a shop smoke test the system

FRED reads freeze frame and live data, so you can see what the engine was doing when P0442 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace gas cap$15–$40
Smoke test to locate leak$100–$200
Replace EVAP hose or purge/vent valve$100–$400
Replace charcoal canister$250–$700
Replace fuel filler neck$250–$600

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0442 FAQ

Most use a smoke machine that fills the system with harmless visible vapor at low pressure, so the leak shows up as escaping smoke.
It is a reasonable and inexpensive first step, especially if the seal is cracked or the cap does not click. If the code returns, the leak is elsewhere.

Related codes