OBD-II trouble code · Powertrain (engine and transmission)

P0456 Evaporative Emission Control System Leak Detected (Very Small Leak)

The engine computer detected a very small leak in the fuel vapor (EVAP) system. These tiny leaks can be tricky to find, but gas cap seals, hoses, and valves are common culprits.

SeverityLow
Safe to drive?Generally safe to drive because the engine still runs normally, but get it fixed to keep fuel vapors in and pass inspection. If you smell strong raw fuel or see fuel leaking, stop driving and have it inspected by a pro, because that is a fire risk.

I've got a teeny-tiny vapor leak somewhere. It's not urgent, but a smoke test is the best way to sniff it out.

— FRED, speaking as your car

What P0456 means

The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. To check for leaks, the PCM seals the system (closing the vent valve) and watches whether it holds vacuum or pressure, using the fuel tank pressure sensor; some vehicles use a separate leak-check pump or module instead. This code was set because the system lost vacuum or pressure at a rate that indicates a very small leak, on the order of about 0.5 mm (0.020-inch) on many vehicles. Leak sizes, test conditions, and test hardware vary by make.

Common symptoms

  • Check engine light on
  • Usually no change in how the car drives
  • Possible faint fuel smell, especially near the rear of the car
  • Possible 'check fuel cap' message on some vehicles
  • Failed emissions inspection

Likely causes (most likely first)

  1. Worn gas cap seal or incorrect cap
  2. Tiny crack in an EVAP hose or connector
  3. Slightly leaking purge or vent valve
  4. Leaking filler neck seal or rusted filler neck
  5. Leaking charcoal canister
  6. Leaking fuel tank sending unit or pump seal
  7. Faulty fuel tank pressure sensor

What you can check yourself

  1. Check the gas cap: make sure it is the correct type, inspect the rubber seal for cracks, and tighten until it clicks
  2. Clear the code and drive normally for several days to allow the EVAP monitor to rerun
  3. Visually inspect the filler neck and any EVAP hoses you can safely see for cracks, rust, or disconnection
  4. Check the purge and vent valve areas for disconnected or damaged hoses
  5. Look up whether your vehicle uses a leak-detection pump or module and check its hoses and connector
  6. If the code returns, have a shop smoke test the system

FRED reads freeze frame and live data, so you can see what the engine was doing when P0456 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace gas cap$15–$40
Smoke test to locate leak$100–$200
Replace EVAP hose or purge/vent valve$100–$400
Replace charcoal canister$250–$700
Replace fuel filler neck$250–$600

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0456 FAQ

The opening may be no larger than a pinhole, and it may only leak when warm or under certain conditions. A smoke test with a bright light is the most reliable way to find it.
Yes, it generally does not affect how the engine runs. However, the check-engine light stays on and can hide new problems, and you may fail inspection, so it is worth fixing.

Related codes