OBD-II trouble code · Powertrain (engine and transmission)

P0446 Evaporative Emission Control System Vent Control Circuit Malfunction

The engine computer found a problem with the EVAP vent control circuit or vent valve, which opens and closes the fuel vapor system to the outside air. A stuck or failed vent valve, wiring, or a clogged vent filter are common causes.

SeverityLow
Safe to drive?Generally safe to drive; if the vent is blocked, you may have trouble filling the tank, but the engine should run normally. Get it fixed to pass inspection. If you smell strong raw fuel or see fuel leaking, stop driving and have it inspected by a pro, because that is a fire risk.

My fuel system's breathing valve isn't doing its job. If the gas pump keeps clicking off on you, my vent is probably blocked.

— FRED, speaking as your car

What P0446 means

The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. A vent valve, usually near the charcoal canister, lets fresh air in and is closed by the PCM during leak tests. This code was set because the vent system did not perform as commanded; depending on the vehicle, that can be an electrical circuit fault or a vent that does not open or close properly (for example, blocked by dirt or spider webs). Definitions and test methods vary by make.

Common symptoms

  • Check engine light on
  • Fuel pump nozzle clicking off early when refueling
  • Usually no change in drivability
  • Possible other EVAP leak codes
  • Failed emissions inspection

Likely causes (most likely first)

  1. Failed vent valve or solenoid
  2. Blocked vent filter or vent hose (dirt, mud, insects)
  3. Damaged wiring or connector at the vent valve
  4. Faulty charcoal canister
  5. Blown fuse (on some vehicles)
  6. Faulty fuel tank pressure sensor

What you can check yourself

  1. Locate the vent valve, usually near the charcoal canister close to the fuel tank or rear axle
  2. Inspect the vent valve connector and wiring for corrosion or road damage
  3. Check the vent hose and filter for dirt, mud, or blockage
  4. Measure solenoid coil resistance with a multimeter and compare to spec
  5. Use a scan tool to command the vent valve and listen for clicking
  6. If you have trouble refueling, note it; that points to a blocked vent

FRED reads freeze frame and live data, so you can see what the engine was doing when P0446 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace vent valve or solenoid$150–$400
Clean or replace vent filter or hose$50–$200
Repair wiring or connector$100–$300
Replace charcoal canister$250–$700

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0446 FAQ

If the EVAP vent is blocked, air cannot leave the tank as fuel goes in, so the pump nozzle senses pressure and shuts off early.
Sometimes clearing a blocked vent filter or hose helps, but if the valve is electrically or mechanically failed it needs replacing.

Related codes