OBD-II trouble code · Powertrain (engine and transmission)

P0449 Evaporative Emission Control System Vent Valve/Solenoid Circuit Malfunction

The engine computer found an electrical problem with the EVAP vent valve or solenoid circuit. That usually means a failed vent solenoid, a damaged wire, or a bad connector.

SeverityLow
Safe to drive?Generally safe to drive because this is an emissions circuit, though you may notice trouble refueling if the valve is stuck closed; get it repaired to pass inspection. If you smell strong raw fuel or see fuel leaking, stop driving and have it inspected by a pro, because that is a fire risk.

The wiring to my EVAP vent valve has a problem, or the valve itself has quit. Since it lives under me near the tank, check that connector for corrosion first.

— FRED, speaking as your car

What P0449 means

The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. The vent valve or solenoid opens and closes the system to fresh air and is controlled electrically by the PCM. This code was set because the circuit's voltage or current did not match the commanded state, such as an open circuit or a short. Because the vent valve is often mounted under the car near the fuel tank, its wiring and connector are exposed to water, salt, and debris. Circuit design varies by make.

Common symptoms

  • Check engine light on
  • Possible trouble filling the fuel tank
  • Usually no drivability change
  • Possible other EVAP codes
  • Failed emissions inspection

Likely causes (most likely first)

  1. Failed vent valve solenoid coil
  2. Corroded or loose connector at the vent valve
  3. Damaged wiring under the vehicle
  4. Blown fuse (on some vehicles)
  5. PCM driver fault (rare)

What you can check yourself

  1. Locate the vent valve, usually near the charcoal canister close to the fuel tank
  2. Inspect its connector for corrosion, water, or broken locks
  3. Follow the wiring for damage from road debris or rubbing
  4. Check related fuses using the owner's manual chart
  5. Measure the solenoid coil resistance with a multimeter and compare to spec
  6. Command the valve with a scan tool and listen for a click

FRED reads freeze frame and live data, so you can see what the engine was doing when P0449 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace vent valve or solenoid$150–$400
Repair vent valve wiring or connector$100–$300
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0449 FAQ

Both involve the vent system. P0449 points specifically to the vent valve or solenoid electrical circuit, while P0446 can cover vent control circuit or performance problems depending on the vehicle.
Yes. Vent valves near the fuel tank are exposed to water and salt, which can corrode connectors and wiring.

Related codes