OBD-II trouble code · Powertrain (engine and transmission)

P0441 Evaporative Emission Control System Incorrect Purge Flow

The engine computer is not seeing the expected flow of fuel vapor from the charcoal canister into the engine during a purge. A faulty purge valve or a blocked or leaking hose are common causes.

SeverityLow
Safe to drive?Generally safe to drive, though a purge valve stuck open can cause rough idle or hard starting right after refueling; get it repaired to pass inspection. If you smell strong raw fuel or see fuel leaking, stop driving and have it inspected by a pro, because that is a fire risk.

My fuel-vapor purge isn't flowing like it should. The purge valve is the usual suspect, and it's often an easy part to swap.

— FRED, speaking as your car

What P0441 means

The evaporative emission (EVAP) system traps fuel vapors from the fuel tank in a charcoal canister and later draws them into the engine to be burned, instead of letting them escape into the air. When the PCM opens the purge valve, it expects a change such as vacuum building in the system (measured by the fuel tank pressure sensor) or a shift in fuel trims or idle. This code was set because the purge flow was not what the PCM expected: too little, too much, or flow when the valve should be closed. Detection methods vary by make.

Common symptoms

  • Check engine light on
  • Hard starting right after refueling (if purge valve sticks open)
  • Rough idle on some vehicles
  • Fuel smell on some vehicles
  • Failed emissions inspection

Likely causes (most likely first)

  1. Faulty purge valve (stuck open or closed)
  2. Cracked, disconnected, or blocked purge hose
  3. Clogged or damaged charcoal canister
  4. Faulty fuel tank pressure sensor
  5. Faulty vent valve
  6. Wiring or connector problem at the purge valve

What you can check yourself

  1. Inspect the purge valve hoses near the engine for cracks or disconnection
  2. Check the purge valve connector and wiring
  3. With the engine off, disconnect the hose to the intake side of the purge valve and gently blow through it; most purge valves should be closed when unpowered (check your vehicle's spec)
  4. Use a scan tool to command the purge valve on and off and listen or feel for clicking
  5. Check for other EVAP codes that point to a specific component
  6. If the car is hard to start after fueling, avoid topping off past the first pump click

FRED reads freeze frame and live data, so you can see what the engine was doing when P0441 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace purge valve (solenoid)$120–$300
Replace purge hose$75–$250
Replace charcoal canister$250–$700
Smoke test and diagnosis$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0441 FAQ

Yes. If the purge valve sticks open, fuel vapor can flood the intake, especially after refueling, making the engine hard to start or idle rough.
Overfilling past the first pump click can push liquid fuel into the charcoal canister, which can damage it and cause EVAP problems.

Related codes