OBD-II trouble code · Powertrain (engine and transmission)

P0400 Exhaust Gas Recirculation Flow Malfunction

The engine computer found a problem with the exhaust gas recirculation (EGR) system, which feeds a small amount of exhaust back into the engine to lower combustion temperatures and emissions. The flow is not what the computer expects, often because of carbon buildup or a faulty valve.

SeverityModerate
Safe to drive?Usually safe to drive short-term if the engine idles and runs normally, but have it checked soon because poor EGR flow can cause engine knock (pinging) and too much flow can cause stalling; if the engine stalls or the check-engine light flashes, stop driving.

Something's off with my exhaust gas recirculation flow. Usually it's just carbon gunking me up, so a cleaning may be all I need.

— FRED, speaking as your car

What P0400 means

The EGR system routes a metered amount of exhaust gas back into the intake to cool combustion and reduce nitrogen oxide (NOx) emissions. The PCM checks EGR flow using a pressure sensor, position sensor, or changes in intake manifold pressure or fuel trims when it commands the valve. This general code was set because the measured flow did not match what the PCM commanded. Many modern engines use variable valve timing for some or all exhaust gas recirculation instead of a separate EGR valve, and EGR hardware and test methods vary widely by make.

Common symptoms

  • Check engine light on
  • Engine pinging or knocking under acceleration
  • Rough idle or stalling if the valve sticks open
  • Hesitation or reduced power
  • Failed emissions test (higher NOx)

Likely causes (most likely first)

  1. Carbon-clogged EGR passages or ports
  2. Stuck or failed EGR valve
  3. Faulty EGR position or pressure (DPFE) sensor
  4. Cracked or disconnected vacuum or pressure hoses
  5. Faulty EGR control solenoid or wiring
  6. Damaged electrical connector

What you can check yourself

  1. Check freeze-frame data and look for other EGR or MAP sensor codes
  2. Visually inspect EGR vacuum and pressure hoses for cracks or disconnection
  3. Inspect EGR connectors and wiring for corrosion or damage
  4. On vehicles that support it, use a scan tool to command the EGR valve and watch whether position or idle changes (idle should get rough if flow is working)
  5. With the engine off and cool, remove the EGR valve if accessible and look for heavy carbon in the valve and port
  6. Clean light carbon with throttle-body or EGR cleaner and recheck

FRED reads freeze frame and live data, so you can see what the engine was doing when P0400 set, before you buy any parts.

Typical repair costs

RepairTypical range
Clean EGR valve and passages$150–$500
Replace EGR valve$250–$700
Replace EGR pressure (DPFE) or position sensor$100–$300
Replace hoses or control solenoid$75–$300

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0400 FAQ

No. Disabling or blocking emissions equipment is illegal for road vehicles in the US and will usually cause more codes and failed inspections. Repair the system instead.
It can, especially with lots of short trips or idling. Regular highway driving and following the maintenance schedule help.

Related codes