OBD-II trouble code · Powertrain (engine and transmission)

P0404 Exhaust Gas Recirculation Circuit Range/Performance

The engine computer sees that the EGR valve is not moving to the position it commanded, or its position sensor reading does not make sense. Carbon sticking the valve or a faulty valve or sensor are common causes.

SeverityModerate
Safe to drive?Usually safe to drive short-term if the engine runs normally, but repair it soon because a sticking valve can cause rough idle or stalling; if the engine stalls or the check-engine light flashes, stop driving.

My EGR valve isn't landing where I tell it to go. It might be sticky with carbon, or its position sensor may be telling tales.

— FRED, speaking as your car

What P0404 means

On vehicles with an electronic EGR valve, the PCM commands a valve position and reads back the actual position from a sensor built into or attached to the valve. This code was set because the actual position or signal was outside the expected range compared to what was commanded, such as a valve that is sticking, moving slowly, or reporting an implausible position. Many modern engines use variable valve timing for some or all exhaust gas recirculation instead of a separate EGR valve, and EGR hardware and test methods vary widely by make.

Common symptoms

  • Check engine light on
  • Rough or unstable idle
  • Hesitation or stalling on some vehicles
  • Engine pinging under load
  • Failed emissions test

Likely causes (most likely first)

  1. Carbon buildup causing the EGR valve to stick
  2. Failed electronic EGR valve or built-in position sensor
  3. Damaged wiring or connector at the EGR valve
  4. Poor power or ground to the valve
  5. Restricted EGR passages
  6. PCM or software issue (rare)

What you can check yourself

  1. Check for other EGR codes, such as position sensor high or low codes
  2. Inspect the EGR valve connector and wiring for corrosion, damage, or loose pins
  3. Use a scan tool to compare commanded versus actual EGR position at idle and during a command test, if supported
  4. Remove the EGR valve if accessible and check for carbon
  5. Clean carbon from the valve and port and recheck
  6. If readings are still off, check power, ground, and signal at the connector using a wiring diagram for your vehicle

FRED reads freeze frame and live data, so you can see what the engine was doing when P0404 set, before you buy any parts.

Typical repair costs

RepairTypical range
Clean EGR valve and passages$150–$500
Replace electronic EGR valve$250–$800
Repair EGR wiring or connector$100–$300
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0404 FAQ

Often, if the valve is sticking from carbon. If the valve motor or position sensor is faulty, the valve will need to be replaced.
Not all do. Many modern engines achieve EGR with valve timing alone. If this code appears, your vehicle has some form of EGR hardware; a repair manual will show where it is.

Related codes