OBD-II trouble code · Powertrain (engine and transmission)

P0401 Exhaust Gas Recirculation Flow Insufficient Detected

The engine computer is not seeing enough exhaust gas recirculation (EGR) flow when it asks for it. This is very often caused by carbon clogging the EGR valve or its passages.

SeverityModerate
Safe to drive?Usually safe to drive short-term, but repair it soon because low EGR flow can cause engine pinging under load, which over time can damage the engine; if pinging is heavy or the check-engine light flashes, stop driving.

I'm not getting enough exhaust gas recirculated, and that can make me ping when I work hard. A good carbon cleanout often fixes me right up.

— FRED, speaking as your car

What P0401 means

When the PCM opens the EGR valve, it expects to see a measurable change, such as an increase in intake manifold pressure, a change in a differential pressure (DPFE) sensor reading, or a shift in fuel trims. This code was set because that change was smaller than expected, meaning too little exhaust is flowing back into the engine. Without enough EGR, combustion temperatures rise, which can increase NOx emissions and cause pinging. Many modern engines use variable valve timing for some or all exhaust gas recirculation instead of a separate EGR valve, and EGR hardware and test methods vary widely by make.

Common symptoms

  • Check engine light on
  • Pinging or knocking when accelerating or climbing hills
  • Higher NOx emissions and possible failed smog test
  • Often little other change in drivability
  • Slightly reduced fuel economy on some vehicles

Likely causes (most likely first)

  1. Carbon-clogged EGR passages, ports, or intake runners
  2. EGR valve stuck closed or failed
  3. Faulty DPFE or EGR pressure sensor
  4. Cracked, plugged, or disconnected EGR pressure or vacuum hoses
  5. Faulty EGR vacuum solenoid or wiring
  6. Restricted EGR cooler (on some engines, especially diesels)

What you can check yourself

  1. Inspect EGR hoses for cracks, melting, or blockage; on DPFE-equipped engines, check both small hoses to the exhaust tube
  2. Check the EGR valve and sensor connectors for corrosion or damage
  3. Command the EGR valve open with a scan tool if supported, or on older vacuum valves apply vacuum by hand at idle; the engine should stumble if gas is flowing
  4. Remove the EGR valve if easily accessible and check for heavy carbon in the valve and port
  5. Clean carbon from the valve and passages and recheck
  6. Clear the code and road-test with a steady highway cruise to let the monitor run

FRED reads freeze frame and live data, so you can see what the engine was doing when P0401 set, before you buy any parts.

Typical repair costs

RepairTypical range
Clean EGR valve and passages$150–$500
Replace EGR valve$250–$700
Replace DPFE or EGR pressure sensor$100–$300
Clean or replace EGR cooler (where equipped)$500–$2,000

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0401 FAQ

No. Clogged passages are a very common cause, and the valve itself may be fine. Cleaning and checking hoses and sensors first can save money.
EGR helps keep combustion temperatures down. With too little EGR, the fuel can ignite too early and cause pinging. Using the fuel grade recommended in your owner's manual also matters.

Related codes