OBD-II trouble code · Powertrain (engine and transmission)

P0402 Exhaust Gas Recirculation Flow Excessive Detected

The engine computer is seeing too much exhaust gas recirculation (EGR) flow, or flow when there should be none. That can make the engine idle rough, hesitate, or even stall.

SeverityModerate
Safe to drive?Drive cautiously and get it repaired soon, because excessive EGR flow can cause stalling at idle or when coming to a stop, which can be dangerous in traffic; if the engine stalls repeatedly or the check-engine light flashes, stop driving and see a pro.

Too much exhaust is sneaking back into my intake, which can make me stumble or stall. Let's get that EGR valve closing properly again.

— FRED, speaking as your car

What P0402 means

The PCM expects little or no EGR flow at idle and under certain conditions, and a controlled amount at others. This code was set because the measured flow (via a pressure sensor, position sensor, or intake manifold pressure change) was higher than commanded. A common reason is an EGR valve stuck partly open from carbon, or a faulty control solenoid or sensor giving a false reading. Many modern engines use variable valve timing for some or all exhaust gas recirculation instead of a separate EGR valve, and EGR hardware and test methods vary widely by make.

Common symptoms

  • Check engine light on
  • Rough idle
  • Stalling at idle or when stopping
  • Hesitation or stumble on acceleration
  • Hard starting
  • Poor fuel economy

Likely causes (most likely first)

  1. EGR valve stuck partly open from carbon
  2. Faulty EGR control solenoid or vacuum regulator
  3. Faulty DPFE or EGR position sensor reporting incorrectly
  4. Incorrect vacuum hose routing after previous work
  5. Wiring short in the EGR control circuit
  6. Clogged sensor hoses giving a false reading

What you can check yourself

  1. Check for other EGR, MAP, or idle-related codes
  2. Verify vacuum and pressure hose routing against the under-hood emissions label or a diagram
  3. Inspect EGR wiring and connectors
  4. With a scan tool, check EGR position or DPFE readings at idle with the valve commanded closed; a reading showing flow suggests a stuck valve or bad sensor
  5. Remove the EGR valve if accessible and look for carbon holding it open
  6. Clean the valve seat and recheck operation

FRED reads freeze frame and live data, so you can see what the engine was doing when P0402 set, before you buy any parts.

Typical repair costs

RepairTypical range
Clean EGR valve and seat$150–$400
Replace EGR valve$250–$700
Replace DPFE or EGR position sensor$100–$300
Replace EGR control solenoid$100–$300

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0402 FAQ

Yes. Too much exhaust at idle dilutes the air-fuel mixture, which can make the engine idle roughly or stall.
They are opposites. P0401 means too little flow and P0402 means too much. Both are often caused by carbon or a faulty valve or sensor.

Related codes