OBD-II trouble code · Powertrain (engine and transmission)

P0344 Camshaft Position Sensor A Circuit Intermittent (Bank 1 or Single Sensor)

Your camshaft position sensor signal keeps dropping out from time to time. This is usually caused by a loose connection, damaged wiring, or a failing sensor.

SeverityModerate
Safe to drive?Usually drivable for short trips to get it checked, but the engine may stall or hesitate unexpectedly, so avoid highway driving until it is fixed.

My camshaft sensor keeps cutting out on me for a second at a time. It's often just a loose plug or worn wire, so let's start there.

— FRED, speaking as your car

What P0344 means

The engine computer expects a steady signal from camshaft position sensor A on bank 1 whenever the engine runs. P0344 sets when that signal cuts out intermittently, meaning it works most of the time but drops for brief moments. This often points to a loose connector, a wire that breaks contact when the engine moves or heats up, oil contamination, or a sensor starting to fail. Intermittent faults can be hard to find, and the exact setting conditions vary by make.

Common symptoms

  • Intermittent stalling or hesitation
  • Check-engine light that comes and goes
  • Occasional hard starting
  • Rough running at times
  • Engine runs fine most of the time

Likely causes (most likely first)

  1. Loose or corroded connector
  2. Wiring that breaks contact with heat or vibration
  3. Oil leak contaminating the connector
  4. Failing camshaft position sensor
  5. Damaged harness rubbing on engine parts
  6. Poor engine or sensor ground

What you can check yourself

  1. Note when the problem happens, such as hot, cold, or over bumps
  2. Inspect the connector for loose pins, corrosion, or oil
  3. With the engine idling and live data on, gently wiggle the wiring and watch for signal changes or stumbles, staying clear of belts and fans
  4. Check the harness for rub-through spots along its route
  5. Clean the connector with electrical contact cleaner and reseat it
  6. Replace the sensor only after wiring and connector check out

FRED reads freeze frame and live data, so you can see what the engine was doing when P0344 set, before you buy any parts.

Typical repair costs

RepairTypical range
Clean or repair connector$75–$250
Repair wiring harness$100–$400
Replace camshaft position sensor$120–$350
Fix oil leak contaminating connector$150–$500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0344 FAQ

Intermittent faults depend on heat, vibration, or moisture. The code may clear itself and return when the same conditions happen again.
They involve the same sensor. P0340 is a general circuit fault, while P0344 specifically means the signal drops out intermittently.

Related codes