OBD-II trouble code · Powertrain (engine and transmission)

P0300 Random/Multiple Cylinder Misfire Detected

Your engine computer has noticed that more than one cylinder, or random cylinders, are not burning fuel properly. Because the problem is not tied to a single cylinder, the cause is usually something shared by the whole engine, like fuel, air, or ignition.

SeverityHigh
Safe to drive?Drive only gently and briefly to get it checked if the check-engine light is steady; if the light is flashing, stop driving, because heavy misfiring can quickly overheat and destroy the catalytic converter.

Several of my cylinders are skipping beats, and it is not just one of them, so something they all share is probably off. If my check-engine light starts flashing, please pull over and give me a rest.

— FRED, speaking as your car

What P0300 means

The engine computer watches how smoothly the crankshaft spins. Every time a cylinder fires, the crankshaft speeds up slightly; when a cylinder fails to fire, that little push is missing. P0300 sets when the computer sees misfires across several cylinders, or misfires that move around, often enough to raise emissions or risk overheating the catalytic converter. Because multiple cylinders are involved, it usually points to a problem that affects every cylinder, such as a vacuum leak, low fuel pressure, worn spark plugs, or a timing issue. Exact detection thresholds and strategies vary by make.

Common symptoms

  • Check-engine light on or flashing
  • Rough or shaky idle
  • Hesitation, stumbling, or loss of power when accelerating
  • Poor fuel economy
  • Raw fuel or rotten-egg smell from the exhaust
  • Engine runs worse under load, such as climbing hills

Likely causes (most likely first)

  1. Worn or fouled spark plugs
  2. Vacuum leak (cracked hose, intake gasket, PCV system)
  3. Low fuel pressure from a weak pump, clogged filter, or faulty regulator
  4. Dirty or failing mass airflow sensor
  5. Several weak ignition coils or bad plug wires
  6. Clogged or leaking fuel injectors
  7. Mechanical problems such as low compression or incorrect cam timing

What you can check yourself

  1. Scan for other codes; lean codes like P0171/P0174 or sensor codes often point to the real cause
  2. Check freeze-frame data to see the RPM, load, and temperature when the misfire happened
  3. Listen for hissing at idle and inspect vacuum hoses and the intake boot for cracks
  4. Look at live misfire counters (Mode 6 or live data) to see which cylinders misfire most
  5. Pull and inspect spark plugs for wear, oil, carbon, or wrong gap
  6. Clean the mass airflow sensor with dedicated MAF cleaner and recheck fuel trims

FRED reads freeze frame and live data, so you can see what the engine was doing when P0300 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace spark plugs$120–$450
Find and repair vacuum leak$100–$450
Replace ignition coil(s)$150–$600
Replace fuel pump or fuel filter$400–$1,200
Compression/leak-down testing and mechanical diagnosis$100–$250

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0300 FAQ

Yes, contaminated or water-laden fuel can cause random misfires. If the code appeared right after a fill-up, that is worth considering, but check the more common causes like plugs and vacuum leaks too.
No. Clearing it only turns off the light. If the underlying cause is still there, the code will come back, usually within a few drive cycles.

Related codes