OBD-II trouble code · Powertrain (engine and transmission)

P0341 Camshaft Position Sensor A Circuit Range/Performance (Bank 1 or Single Sensor)

Your camshaft position sensor is sending a signal, but it is not lining up with what the engine computer expects. This can mean a sensor or wiring problem, or that the engine's timing has shifted.

SeverityModerate
Safe to drive?Drive only short distances to get it checked; if you hear rattling from the front of the engine or it runs very poorly, stop driving, because a timing chain or belt problem can lead to serious engine damage.

My camshaft and crankshaft aren't quite agreeing on where they are. It could be a sensor, but if you hear me rattling at startup, my timing chain might be stretched.

— FRED, speaking as your car

What P0341 means

The engine computer compares the camshaft position signal with the crankshaft position signal to confirm cam and crank are in sync. P0341 sets when the cam sensor A signal on bank 1 is present but erratic, missing pulses, or out of the expected relationship with the crank signal. This can be caused by a failing sensor, wiring issues, debris on the sensor, a damaged reluctor, or a stretched or jumped timing chain or belt. Details vary by make, and some engines are more prone to timing chain wear than others.

Common symptoms

  • Hard starting or long cranking
  • Check-engine light on
  • Rough idle or misfires
  • Reduced power
  • Rattling noise at startup if timing chain is stretched
  • Stalling in some cases

Likely causes (most likely first)

  1. Failing camshaft position sensor
  2. Damaged wiring or connector
  3. Debris or damage on the sensor tip
  4. Stretched timing chain or worn guides
  5. Timing belt or chain jumped a tooth
  6. Damaged cam reluctor

What you can check yourself

  1. Scan for related crank, cam timing, or correlation codes like P0016
  2. Listen for rattling from the timing cover at cold startup
  3. Inspect the sensor connector and wiring for oil, corrosion, or damage
  4. Remove and inspect the sensor tip for debris
  5. Check engine oil level and condition, since poor oil can affect chain tensioners
  6. If a sensor replacement does not fix it, have timing checked by a shop

FRED reads freeze frame and live data, so you can see what the engine was doing when P0341 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace camshaft position sensor$120–$350
Repair wiring or connector$100–$400
Timing belt replacement$500–$1,200
Timing chain and guide replacement$1,000–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0341 FAQ

Clues for the chain include rattling at startup and correlation codes like P0016. A shop can verify timing alignment or compare cam and crank signals with a scope.
Yes, if it is the wrong part, not fully seated, or a low-quality unit. Use the correct sensor and verify the connector is clean.

Related codes