OBD-II trouble code · Powertrain (engine and transmission)

P0335 Crankshaft Position Sensor A Circuit Malfunction

Your engine computer is not getting a proper signal from the crankshaft position sensor, which tells it how fast and where the engine is turning. Without it, the engine may stall or refuse to start.

SeverityHigh
Safe to drive?Not recommended, because the engine can stall suddenly or fail to restart, which can leave you stranded or create a hazard in traffic.

I can't feel my crankshaft turning, so I don't know when to fire my spark plugs. If I stall or won't start, this sensor is a strong suspect.

— FRED, speaking as your car

What P0335 means

The crankshaft position sensor reads a toothed wheel on the crankshaft and sends a signal the engine computer uses for spark timing, fuel injection, and misfire detection. P0335 sets when the computer sees no signal or an invalid signal from crank sensor A while the engine is cranking or running, often because the cam sensor shows the engine turning but the crank sensor does not. Causes include a failed sensor, wiring or connector damage, or a damaged reluctor wheel. Sensor location and test procedures vary by make.

Common symptoms

  • Engine cranks but will not start
  • Sudden stalling, often when warm
  • Intermittent misfires or stumbling
  • Tachometer not moving while cranking
  • Check-engine light on
  • Hard starting

Likely causes (most likely first)

  1. Failed crankshaft position sensor
  2. Damaged or oil-soaked wiring or connector
  3. Damaged or missing teeth on the reluctor wheel
  4. Debris on a magnetic sensor tip
  5. Incorrect sensor gap or poor installation
  6. Engine computer fault (rare)

What you can check yourself

  1. Watch RPM in live data while cranking; no RPM reading suggests no crank signal
  2. Check for other codes, such as cam sensor codes
  3. Locate the sensor and inspect the connector and wiring for damage or oil contamination
  4. Remove the sensor if accessible and check the tip for damage or metal debris
  5. Test sensor resistance or signal with a multimeter per the service manual
  6. Make sure any replacement sensor is the correct part for your engine

FRED reads freeze frame and live data, so you can see what the engine was doing when P0335 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace crankshaft position sensor$150–$450
Repair wiring or connector$100–$400
Replace damaged reluctor wheel$400–$2,500
Engine computer repair or replacement$500–$1,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0335 FAQ

Yes. On most vehicles, without a crank signal the computer will not fire the coils or injectors, so the engine cranks but does not start.
Some failing crank sensors stop working when they get hot, then work again once cooled. That pattern is a common clue.

Related codes