OBD-II trouble code · Powertrain (engine and transmission)

P0011 Intake Camshaft Position Timing Over-Advanced Bank 1

The variable valve timing system has moved the intake camshaft further ahead than the computer asked for on bank 1. This is often related to engine oil level or condition, or a sticking timing control solenoid.

SeverityModerate
Safe to drive?Usually okay to drive gently in the short term after confirming oil level, but if oil is low, the engine rattles, or it runs poorly, stop and get it checked to avoid engine damage.

My intake camshaft is running further ahead than I asked for. Check my oil first, since my timing system depends on clean oil at the right level.

— FRED, speaking as your car

What P0011 means

Many engines use variable valve timing, which uses oil pressure and a control solenoid to rotate the intake camshaft for better power and efficiency. The engine computer commands a cam position and checks the actual position using the cam and crank sensors. P0011 sets when the actual intake cam timing on bank 1 is more advanced than commanded, or does not respond as expected. Low or dirty oil, the wrong oil viscosity, a sticking oil control solenoid, a clogged oil screen, a worn cam phaser, or a stretched timing chain can cause it. Bank 1 is the side with cylinder 1. Details vary by make.

Common symptoms

  • Check-engine light on
  • Rough idle or stalling
  • Reduced power
  • Worse fuel economy
  • Rattling at startup
  • Hard starting in some cases

Likely causes (most likely first)

  1. Low engine oil level
  2. Dirty or wrong-viscosity oil
  3. Sticking or failing oil control solenoid
  4. Clogged oil screen at the solenoid
  5. Worn or sticking cam phaser
  6. Stretched timing chain or worn guides

What you can check yourself

  1. Check engine oil level and condition right away
  2. Confirm the oil used matches the viscosity in your owner's manual
  3. Change the oil and filter if it is dirty, low, or overdue
  4. Inspect the oil control solenoid connector and wiring
  5. Remove and inspect the solenoid and its screen for sludge if accessible
  6. Clear the code and recheck; if it returns, have the phaser and timing chain checked

FRED reads freeze frame and live data, so you can see what the engine was doing when P0011 set, before you buy any parts.

Typical repair costs

RepairTypical range
Oil and filter change$50–$120
Replace oil control solenoid$150–$450
Replace cam phaser$800–$2,000
Timing chain and guide replacement$1,000–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0011 FAQ

Sometimes. Low, dirty, or wrong-viscosity oil is a common cause. If the code returns after a fresh oil change, the solenoid or phaser is next.
They involve the same system. P0011 means the intake cam is more advanced than commanded, while P0012 means it is more retarded than commanded.

Related codes