OBD-II trouble code · Powertrain (engine and transmission)
P0336 Crankshaft Position Sensor A Circuit Range/Performance
Your crankshaft position sensor is sending a signal, but it does not look right to the engine computer. This can cause stalling, misfires, or hard starting.
My crank sensor is talking, but the message keeps cutting in and out. Let's check its wiring and tip before I leave you stranded.
— FRED, speaking as your car
What P0336 means
The engine computer expects a clean, consistent pattern from the crankshaft position sensor as teeth on the reluctor wheel pass by. P0336 sets when the signal is present but erratic, missing pulses, or does not match what the computer expects compared with other signals like the camshaft sensor. Common reasons include a damaged reluctor wheel, debris on the sensor, a failing sensor, poor wiring connections, or electrical interference. Details and the reluctor wheel design vary by make.
Common symptoms
- Intermittent stalling
- Hard starting or long cranking
- Misfires or stumbling
- Erratic tachometer
- Check-engine light on
- Reduced power
Likely causes (most likely first)
- Failing crankshaft position sensor
- Damaged or bent reluctor wheel teeth
- Metal debris on a magnetic sensor tip
- Loose connector or damaged wiring
- Incorrect sensor installation or gap
- Electrical interference from spark plug wires or aftermarket accessories
What you can check yourself
- Scan for related cam or misfire codes
- Inspect wiring and connector for looseness, corrosion, or chafing
- Remove the sensor if accessible and clean any metal debris from the tip
- Check that wiring is routed away from spark plug wires and alternator cables
- Check that the sensor is fully seated and the correct part
- Review freeze-frame data to see when the code set, such as at startup or high RPM
FRED reads freeze frame and live data, so you can see what the engine was doing when P0336 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace crankshaft position sensor | $150–$450 |
| Repair wiring or connector | $100–$400 |
| Replace damaged reluctor wheel | $400–$2,500 |
| Diagnostic testing with oscilloscope | $100–$250 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.