OBD-II trouble code · Powertrain (engine and transmission)

P0320 Ignition/Distributor Engine Speed Input Circuit Malfunction

Your engine computer is not getting a good engine speed signal from the crankshaft sensor or distributor. Without that signal, the engine may stall, run poorly, or not start at all.

SeverityHigh
Safe to drive?Not recommended, because the engine can stall without warning, which is dangerous in traffic; have it diagnosed before relying on the vehicle.

I'm losing track of how fast I'm spinning, and without that I can't time my spark. If I stall on you, please get me checked before the next trip.

— FRED, speaking as your car

What P0320 means

The engine computer needs a steady engine speed and position signal to time spark and fuel. Depending on the vehicle, that signal comes from a crankshaft position sensor, a distributor pickup, or an ignition module. P0320 sets when the computer sees the signal missing, erratic, or out of expected range while the engine is turning. Common reasons include a failing sensor, damaged wiring or connectors, a bad ignition module, or a damaged reluctor or trigger wheel. Which component supplies this signal varies by make and engine.

Common symptoms

  • Engine stalls suddenly, often when warm
  • Engine cranks but will not start
  • Intermittent misfires or stumbling
  • Tachometer drops to zero or jumps around
  • Check-engine light on
  • Hesitation or loss of power

Likely causes (most likely first)

  1. Failing crankshaft position sensor or distributor pickup
  2. Damaged, chafed, or corroded sensor wiring or connector
  3. Failing ignition control module
  4. Damaged reluctor ring or trigger wheel
  5. Electrical interference from aftermarket wiring or bad grounds
  6. Engine computer fault (less common)

What you can check yourself

  1. Scan for related crank or cam sensor codes
  2. Watch engine RPM on live data while cranking; a zero reading points to a missing signal
  3. Inspect the sensor connector and wiring for damage, oil soaking, or loose pins
  4. Check engine and computer ground connections for corrosion
  5. If the stall happens when hot, note it, since some sensors fail when warm
  6. Check for aftermarket accessories wired near the ignition system

FRED reads freeze frame and live data, so you can see what the engine was doing when P0320 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace crankshaft position sensor$150–$450
Repair sensor wiring or connector$100–$400
Replace ignition control module or distributor$200–$700
Repair ground connections$75–$250
Replace or reprogram engine computer$500–$1,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0320 FAQ

Often the crank sensor is the source, but on some vehicles the signal comes from the distributor or ignition module. Check which part feeds the engine speed signal on your vehicle.
Low voltage during cranking can sometimes trigger signal codes. Make sure the battery and connections are healthy before replacing sensors.

Related codes