OBD-II trouble code · Powertrain (engine and transmission)

P0193 Fuel Rail Pressure Sensor Circuit High Input

The fuel rail pressure sensor's signal is reading higher than possible. That usually points to a wiring problem or a failed sensor, not truly sky-high fuel pressure.

SeverityModerate
Safe to drive?Usually OK to drive gently to a shop, but limp mode or rough running can occur; stop if you smell fuel.

My fuel pressure sensor is shouting a number that's way too high. Most likely it's the sensor or a wire, not my actual fuel system, but let's confirm.

— FRED, speaking as your car

What P0193 means

The fuel rail pressure (FRP) sensor sends a voltage to the PCM that rises with fuel pressure. P0193 sets when that voltage is above the normal maximum for longer than allowed. Common causes are an open ground circuit, a signal wire shorted to voltage, a failed sensor, or connector problems. The PCM may switch to a default pressure value and limit power. Circuit values vary by make.

Common symptoms

  • Check-engine light on
  • Reduced power or limp mode
  • Rough running
  • Hard starting
  • Poor fuel economy
  • Stalling in some cases

Likely causes (most likely first)

  1. Failed fuel rail pressure sensor
  2. Open sensor ground circuit
  3. Signal wire shorted to voltage
  4. Corroded or damaged connector
  5. Harness damage
  6. Rarely, PCM fault

What you can check yourself

  1. Inspect the FRP sensor connector for corrosion, loose pins, or water
  2. Check the harness for chafing or melted spots
  3. Look at live data for a fuel pressure reading stuck at maximum
  4. Check sensor ground and reference voltage with a multimeter per service info
  5. Unplug the sensor and see if the code changes to a low-input code, which helps isolate the sensor
  6. Clear codes and recheck

FRED reads freeze frame and live data, so you can see what the engine was doing when P0193 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair ground or signal wiring$100–$300
Replace fuel rail pressure sensor$150–$450
Replace fuel rail with integrated sensor$400–$1,200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0193 FAQ

Usually not. A high-input circuit code typically means the signal is electrically out of range, often a wiring or sensor fault.
P0193 is a sensor circuit problem. P0088 means the computer believes actual pressure is too high based on a plausible reading.

Related codes