OBD-II trouble code · Powertrain (engine and transmission)

P0190 Fuel Rail Pressure Sensor Circuit Malfunction

The engine computer found an electrical problem with the sensor that measures fuel pressure in the fuel rail. Without a good reading, it can't control fuel pressure accurately.

SeverityModerate
Safe to drive?Short trips to a shop are usually OK if the engine runs normally, but expect possible limp mode or stalling; stop if you smell fuel.

I've lost a clear signal from my fuel pressure sensor, so I'm guessing at fuel pressure. Let's check that wiring and plug before I go into limp mode.

— FRED, speaking as your car

What P0190 means

The fuel rail pressure (FRP) sensor sends a voltage signal to the PCM that represents fuel pressure. P0190 sets when the PCM detects a general fault in this sensor's circuit, such as a missing signal, an open or short, or reference voltage problems. When this happens the PCM may use a default value and limit power. This sensor is common on diesels and direct-injection engines. Sensor location and circuit design vary by make.

Common symptoms

  • Check-engine light on
  • Hard starting or no start
  • Reduced power or limp mode
  • Rough running
  • Stalling
  • Poor fuel economy

Likely causes (most likely first)

  1. Faulty fuel rail pressure sensor
  2. Damaged or corroded sensor connector
  3. Open or shorted wiring in the sensor circuit
  4. Problem with the sensor's 5-volt reference circuit
  5. Ground circuit issue
  6. Rarely, PCM fault

What you can check yourself

  1. Scan for other sensor codes that share the 5-volt reference
  2. Inspect the FRP sensor connector for corrosion or loose fit
  3. Inspect harness routing for chafing
  4. Check live data for a fuel pressure reading that looks frozen or impossible
  5. With a multimeter, check for reference voltage and ground at the connector per service info
  6. Wiggle-test the harness while watching live data

FRED reads freeze frame and live data, so you can see what the engine was doing when P0190 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair connector or wiring$100–$300
Replace fuel rail pressure sensor$150–$450
Replace fuel rail (if sensor is integrated)$400–$1,200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0190 FAQ

It can. Some vehicles won't start or will start poorly if the computer can't read fuel pressure correctly.
Yes. High-pressure systems can hold dangerous pressure. Follow service procedures or have a pro do it.

Related codes