OBD-II trouble code · Powertrain (engine and transmission)
P0141 O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 2
The built-in heater inside the rear oxygen sensor on Bank 1 is not working correctly, or its circuit has a problem. The sensor needs that heat to work properly, especially right after a cold start.
The little heater in my rear oxygen sensor on Bank 1 has quit, so that sensor is slow to wake up. A quick resistance check usually tells us whether it's the sensor or the wiring.
— FRED, speaking as your car
What P0141 means
Oxygen sensors only produce a useful signal when they are very hot, so most have an electric heater inside to bring them up to temperature quickly. The PCM monitors the heater circuit (current draw, voltage, or resistance depending on design) and set this code because the Bank 1 Sensor 2 heater circuit was out of its expected range, such as an open circuit or excessive current. Bank 1 is the side of the engine with cylinder number 1 (on a 4-cylinder engine there is only Bank 1). Sensor 2 is the downstream oxygen sensor, mounted after the catalytic converter, and its main job is to check how well the converter is working. The most common cause is a burned-out heater element inside the sensor, followed by a blown fuse or damaged wiring. Circuit design and test methods vary by make.
Common symptoms
- Check engine light on
- Usually no drivability change
- Higher emissions after cold start
- Emissions readiness monitors may not complete
- May fail an emissions inspection
Likely causes (most likely first)
- Failed heater element inside the oxygen sensor
- Blown fuse for the oxygen sensor heater circuit
- Damaged, melted, or chafed heater wiring
- Corroded or loose connector
- Faulty heater relay or power feed (on some vehicles)
- PCM heater driver fault (rare)
What you can check yourself
- Check whether other heater codes are also set; several at once points to a shared fuse or power feed
- Check the fuse for the oxygen sensor heaters using the owner's manual fuse chart
- Locate the correct sensor: on the cylinder 1 side, after the catalytic converter. A repair manual or online diagram for your exact engine helps, because swapping the wrong sensor is a common and wasted expense.
- Unplug the sensor and measure heater resistance across the heater pins with a multimeter; compare to the spec for your sensor (often just a few ohms; open or infinite means a dead heater)
- With the key on, check for battery voltage at the heater power pin on the vehicle side of the connector
- Inspect the harness for spots touching the exhaust
FRED reads freeze frame and live data, so you can see what the engine was doing when P0141 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace oxygen sensor (heater is not serviceable separately) | $150–$450 |
| Replace blown fuse and find cause | $20–$150 |
| Repair heater wiring or connector | $100–$300 |
| Diagnostic testing at a shop | $100–$200 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.