OBD-II trouble code · Powertrain (engine and transmission)
P0139 O2 Sensor Circuit Slow Response Bank 1 Sensor 2
The rear oxygen sensor on Bank 1 is reacting too slowly to changes in the exhaust. Oxygen sensors wear out with age, so this often points to a tired sensor, though exhaust leaks and wiring can also cause it.
My rear oxygen sensor on Bank 1 has gotten a little slow on the uptake. It's a common sign of age, and a fresh sensor usually gets me sharp again.
— FRED, speaking as your car
What P0139 means
The PCM measures how quickly the Bank 1 Sensor 2 oxygen sensor switches between lean and rich readings, or how fast it responds to events such as fuel shut-off during coasting. It set this code because the response time was slower than the calibrated limit. Bank 1 is the side of the engine with cylinder number 1 (on a 4-cylinder engine there is only Bank 1). Sensor 2 is the downstream oxygen sensor, mounted after the catalytic converter, and its main job is to check how well the converter is working. Sensors slow down as they age or become coated with deposits from oil burning, coolant, or fuel additives. Exhaust leaks, a weak heater, and wiring issues can also slow the signal. Test methods and limits vary by make.
Common symptoms
- Check engine light on
- Usually no drivability change
- Catalyst readiness monitor may not complete
- May fail an emissions inspection
- Possible increase in exhaust odor
Likely causes (most likely first)
- Aged or worn oxygen sensor
- Sensor contaminated by oil, coolant, or silicone
- Exhaust leak near the sensor
- Weak or failing sensor heater
- Wiring or connector problem
- Engine issues such as misfires that disturb the exhaust signal
What you can check yourself
- Check for heater-circuit or misfire codes and address those first
- With your OBD-II app, watch how quickly the rear sensor drops when you coast with the throttle closed and rises when you accelerate; a sluggish change suggests a worn sensor
- Listen for exhaust leaks near the sensor with the engine cold
- Locate the correct sensor: on the cylinder 1 side, after the catalytic converter. A repair manual or online diagram for your exact engine helps, because swapping the wrong sensor is a common and wasted expense.
- Inspect the wiring and connector for heat damage or corrosion
- Consider the sensor's age; original sensors on high-mileage vehicles are common culprits
FRED reads freeze frame and live data, so you can see what the engine was doing when P0139 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace oxygen sensor | $150–$450 |
| Repair exhaust leak | $100–$400 |
| Repair wiring or connector | $100–$300 |
| Diagnostic testing at a shop | $100–$200 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.