OBD-II trouble code · Powertrain (engine and transmission)

P0135 O2 Sensor Heater Circuit Malfunction Bank 1 Sensor 1

The heater inside your upstream oxygen sensor on bank 1 isn't working properly. This heater helps the sensor work quickly after a cold start.

SeverityLow
Safe to drive?Generally safe to drive; fix it soon to restore cold-start emissions and fuel economy.

The little heater in my bank 1 upstream oxygen sensor isn't warming up. Check my fuse first, then the sensor.

— FRED, speaking as your car

What P0135 means

O2 sensors have built-in heaters to reach operating temperature quickly. P0135 sets when the engine computer detects a problem in the bank 1 sensor 1 heater circuit, such as an open heater element, incorrect current draw, or a missing power supply. Usually the sensor's heater has failed, but blown fuses and wiring damage are also common. Details vary by make.

Common symptoms

  • Check-engine light on
  • Slightly worse fuel economy
  • Higher emissions after cold start
  • Failed emissions test
  • Often no noticeable symptoms
  • Possible slow-response O2 codes

Likely causes (most likely first)

  1. Failed O2 sensor heater element
  2. Blown heater fuse
  3. Damaged wiring or connector
  4. Faulty heater relay (some vehicles)
  5. Engine computer heater driver fault (rare)
  6. Corroded terminals

What you can check yourself

  1. Check the O2 heater fuse
  2. Inspect connector and wiring
  3. Measure heater resistance at the sensor connector with a multimeter and compare to specs
  4. Check for power at the heater circuit with key on per a wiring diagram
  5. Replace the sensor if heater resistance is open
  6. If fuse blows repeatedly, look for a wiring short

FRED reads freeze frame and live data, so you can see what the engine was doing when P0135 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace blown fuse$5–$50
Replace upstream O2 sensor$150–$400
Repair wiring$100–$300

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0135 FAQ

No, the heater is built into the sensor, so the whole sensor is replaced.
A blown fuse is a cheap fix and can also affect other sensor heaters. If it blows again, there's likely a short.

Related codes