OBD-II trouble code · Powertrain (engine and transmission)
P0137 O2 Sensor Circuit Low Voltage Bank 1 Sensor 2
The rear oxygen sensor after the catalytic converter on Bank 1 is reporting a voltage that stays too low. This sensor mainly checks the converter, so the car usually runs normally, but it needs attention to pass emissions and keep converter monitoring working.
My rear oxygen sensor on Bank 1 is reading low and stuck. I'll drive fine, but I can't properly check on my catalytic converter until it's sorted.
— FRED, speaking as your car
What P0137 means
The PCM watches the downstream oxygen sensor voltage to judge how well the catalytic converter is storing and using oxygen. It set this code because the Bank 1 Sensor 2 signal stayed below its expected range (it never rose as expected during rich fuel conditions such as acceleration) under the test conditions. Bank 1 is the side of the engine with cylinder number 1 (on a 4-cylinder engine there is only Bank 1). Sensor 2 is the downstream oxygen sensor, mounted after the catalytic converter, and its main job is to check how well the converter is working. Common reasons are an exhaust leak near the sensor that pulls in outside air, a failed sensor, or a signal wire shorted to ground. Test conditions and thresholds vary by make.
Common symptoms
- Check engine light on
- Usually no change in how the car drives
- Catalyst readiness monitor may not complete
- May fail an emissions inspection
- Occasionally a slight drop in fuel economy
Likely causes (most likely first)
- Failed downstream oxygen sensor
- Exhaust leak near the sensor (joint, flange gasket, cracked pipe)
- Signal wire shorted to ground or chafed on the exhaust
- Corroded or loose connector
- Genuine lean running condition (less common for a rear-sensor-only code)
What you can check yourself
- Scan for other codes; lean or misfire codes should be fixed first
- Watch the sensor voltage with your OBD-II app while snapping the throttle or driving; a working rear sensor should rise toward 0.6–0.8 V under rich conditions
- Listen for exhaust ticking or puffing near the converter and rear sensor with the engine cold
- Locate the correct sensor: on the cylinder 1 side, after the catalytic converter. A repair manual or online diagram for your exact engine helps, because swapping the wrong sensor is a common and wasted expense.
- Inspect the sensor wiring for melted or rubbed-through insulation and check the connector for corrosion
- After any repair, clear the code and drive normally for a few days to see if it returns
FRED reads freeze frame and live data, so you can see what the engine was doing when P0137 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace downstream oxygen sensor | $150–$450 |
| Repair exhaust leak near sensor | $100–$400 |
| Repair sensor wiring or connector | $100–$300 |
| Diagnostic testing at a shop | $100–$200 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.