OBD-II trouble code · Powertrain (engine and transmission)

P0138 O2 Sensor Circuit High Voltage Bank 1 Sensor 2

The rear oxygen sensor after the catalytic converter on Bank 1 is reporting a voltage that stays too high. That usually means a sensor or wiring fault, or the engine is running rich, so it is worth checking soon.

SeverityModerate
Safe to drive?Usually safe to drive short-term if the engine runs normally, but a rich condition can overheat and damage the catalytic converter, so have it checked soon; stop driving if the check-engine light flashes or you smell strong fuel.

My rear oxygen sensor on Bank 1 is shouting 'rich!' and won't calm down. Could be the sensor, a wire, or me actually running rich, so let's check before my catalytic converter pays for it.

— FRED, speaking as your car

What P0138 means

The PCM expects the downstream Bank 1 oxygen sensor to read within a normal range and to drop low during conditions such as coasting with the fuel cut off. It set this code because the signal stayed above its expected limit under the test conditions. Bank 1 is the side of the engine with cylinder number 1 (the only bank on a 4-cylinder), and Sensor 2 is the sensor after the catalytic converter. A high reading can come from a sensor that is failing or contaminated (for example by coolant or oil burning), a signal wire shorted to a voltage source such as the heater circuit, or an engine that is genuinely running rich. Details vary by make.

Common symptoms

  • Check engine light on
  • Often no drivability change
  • Possible fuel smell or black smoke if the engine is running rich
  • Reduced fuel economy if rich
  • May fail an emissions inspection

Likely causes (most likely first)

  1. Failed or contaminated downstream oxygen sensor
  2. Signal wire shorted to voltage (often to the sensor's own heater wire)
  3. Engine running rich (leaking injector, high fuel pressure, faulty sensor input)
  4. Coolant or oil contamination of the sensor
  5. Damaged connector or water intrusion

What you can check yourself

  1. Scan for other codes, especially rich or misfire codes, and fix those first
  2. Watch the sensor with your OBD-II app during a closed-throttle coast; the reading should drop low when fuel is cut, and a sensor stuck near 1 V or above suggests a fault
  3. Check fuel trims; strongly negative trims point to a real rich condition
  4. Check for signs of coolant loss or oil burning that could contaminate the sensor
  5. Locate the sensor after the catalytic converter on the cylinder 1 side and inspect its wiring for melted or fused wires
  6. Unplug the sensor (engine off) and inspect the connector for corrosion or moisture

FRED reads freeze frame and live data, so you can see what the engine was doing when P0138 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace downstream oxygen sensor$150–$450
Repair shorted sensor wiring$100–$300
Diagnose and fix rich running condition$150–$700
Diagnostic testing at a shop$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0138 FAQ

Higher voltage normally means the exhaust has very little oxygen, which happens when the mixture is rich. If the voltage is higher than a sensor can normally produce, a short to another voltage source is likely.
It can. Coolant burning in the engine can contaminate oxygen sensors. If you are also losing coolant or see white exhaust smoke, have the cooling system and head gasket checked by a pro.

Related codes