OBD-II trouble code · Powertrain (engine and transmission)
P0123 Throttle/Pedal Position Sensor/Switch A Circuit High Input
Your throttle or pedal position sensor's signal is too high, often from a short or failed sensor. The car may hesitate, surge, or go into reduced-power mode.
My throttle sensor says you're pressing harder than you are. I'll play it safe until we get it fixed.
— FRED, speaking as your car
What P0123 means
P0123 sets when the TPS A signal voltage stays above its maximum. Common causes are a signal wire shorted to voltage, a lost sensor ground, or a failed sensor. On drive-by-wire vehicles the computer may limit power. Details vary by make.
Common symptoms
- Check-engine light on
- High or surging idle
- Reduced-power mode
- Hesitation
- Poor shifting
- Stalling
Likely causes (most likely first)
- Signal wire shorted to voltage
- Lost sensor ground
- Faulty throttle position sensor
- Damaged connector
- Faulty throttle body assembly
- Engine computer fault (rare)
What you can check yourself
- Inspect connector and wiring for damage or shorts
- Check sensor ground continuity
- View live TPS with throttle closed; it should read near closed, not high
- Use a multimeter to test the circuit per a wiring diagram
- Wiggle-test wiring while watching live data
- Replace sensor or throttle body as needed
FRED reads freeze frame and live data, so you can see what the engine was doing when P0123 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Repair wiring or ground | $100–$300 |
| Replace throttle position sensor | $100–$300 |
| Replace electronic throttle body | $300–$900 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.