OBD-II trouble code · Powertrain (engine and transmission)

P0120 Throttle/Pedal Position Sensor/Switch A Circuit Malfunction

The computer has detected a problem with the sensor that reports your throttle or gas pedal position. This can cause hesitation, surging, or reduced-power mode.

SeverityHigh
Safe to drive?Drive only if the vehicle responds normally and predictably; if it surges, hesitates, or enters reduced-power mode, avoid highway driving and get it to a shop because unpredictable throttle response is a safety risk.

I'm not sure how far you're pressing my pedal, so I might play it safe with less power. Let's get my throttle sensor checked soon.

— FRED, speaking as your car

What P0120 means

The throttle position sensor (TPS), or on drive-by-wire vehicles a pedal position sensor, reports how far the throttle or pedal is open. P0120 is a general fault in circuit A: the signal was missing, erratic, or implausible. On electronic throttle vehicles, the computer may limit power for safety. Which sensor circuit A refers to varies by make.

Common symptoms

  • Check-engine light on
  • Hesitation or surging
  • Reduced-power or limp mode
  • Erratic idle
  • Poor shifting on automatics
  • Stalling

Likely causes (most likely first)

  1. Faulty throttle position sensor
  2. Damaged wiring or connector
  3. Faulty pedal position sensor (drive-by-wire)
  4. Corroded terminals
  5. Loss of 5-volt reference or ground
  6. Faulty throttle body assembly

What you can check yourself

  1. Inspect the TPS or throttle body connector and wiring
  2. Check for other sensor codes sharing the 5-volt reference
  3. Watch live TPS percentage while slowly pressing the pedal (key on, engine off); it should rise smoothly without dropouts
  4. Check for corrosion at connector pins
  5. Clean throttle body if heavily carboned (follow manufacturer guidance on electronic throttles)
  6. Have circuit tested if the issue persists

FRED reads freeze frame and live data, so you can see what the engine was doing when P0120 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair wiring or connector$100–$300
Replace throttle position sensor$100–$300
Replace electronic throttle body$300–$900
Replace pedal position sensor$150–$500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0120 FAQ

A protective mode where the computer limits power and rpm when it can't trust throttle data. It lets you drive slowly to a shop.
You can clean the connector, but the sensor itself usually needs replacement if faulty. On many newer vehicles it's part of the throttle body.

Related codes