OBD-II trouble code · Powertrain (engine and transmission)
P0118 Engine Coolant Temperature Circuit High Input
Your engine temperature sensor's signal is too high, which the computer reads as an extremely cold engine. This is often an unplugged connector, broken wire, or failed sensor.
My temperature sensor thinks I'm frozen solid, even when I'm warm. Check that its plug is connected and its wires are intact.
— FRED, speaking as your car
What P0118 means
P0118 sets when the ECT signal voltage stays above its maximum, interpreted as implausibly cold coolant. This usually indicates an open circuit: unplugged connector, broken wire, failed sensor, or poor ground. The computer may enrich fuel and run cooling fans as a precaution. Thresholds vary by make.
Common symptoms
- Check-engine light on
- Temperature gauge stays cold or reads erratically
- Cooling fans running constantly
- Black smoke or rich running
- Poor fuel economy
- Hard starting when warm
Likely causes (most likely first)
- Unplugged or loose ECT connector
- Open or broken signal wire
- Faulty ECT sensor
- Corroded terminals
- Poor ground
- Engine computer fault (rare)
What you can check yourself
- Verify the ECT connector is plugged in and locked
- View live ECT; a reading around minus 40 usually indicates an open circuit
- Inspect the wiring harness for breaks
- Measure sensor resistance against specifications
- Jumper test the connector per a service manual
- Replace the sensor if needed
FRED reads freeze frame and live data, so you can see what the engine was doing when P0118 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Reconnect or repair connector | $50–$150 |
| Replace ECT sensor | $80–$250 |
| Repair broken wiring | $100–$300 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.