OBD-II trouble code · Powertrain (engine and transmission)

P0101 Mass or Volume Air Flow Circuit Range/Performance Problem

Your airflow sensor is working but its readings don't make sense compared to what the engine is doing. This often comes from a dirty sensor or an air leak.

SeverityModerate
Safe to drive?Usually safe to drive short-term, but performance and fuel economy may suffer; have it diagnosed soon and avoid hard driving if the engine hesitates.

My airflow numbers don't add up with what my throttle and rpm are telling me. Check my air filter and intake tube, then give my MAF a gentle cleaning.

— FRED, speaking as your car

What P0101 means

The engine computer compares MAF readings to expected values from throttle position, engine speed, and manifold pressure. P0101 sets when the MAF signal is within its electrical range but out of line with those expectations, such as reading too low or too high for current conditions. Dirt on the sensor, intake leaks after the sensor, and restricted air filters are common causes. Logic and thresholds vary by make.

Common symptoms

  • Check-engine light on
  • Hesitation or flat spot when accelerating
  • Rough idle
  • Poor fuel economy
  • Possible lean or rich codes
  • Occasional stalling

Likely causes (most likely first)

  1. Dirty or contaminated MAF sensor
  2. Air leak between the MAF and throttle body
  3. Clogged air filter
  4. Faulty MAF sensor
  5. Vacuum leak
  6. Exhaust restriction (clogged catalytic converter) on some vehicles

What you can check yourself

  1. Replace or inspect the air filter
  2. Inspect the intake boot and clamps between the MAF and throttle body for cracks or looseness
  3. Clean the MAF sensor with dedicated cleaner
  4. Compare live MAF readings at idle against the expected range in a service manual for your engine
  5. Look at fuel trims; large positive trims suggest unmetered air
  6. Clear the code and road-test

FRED reads freeze frame and live data, so you can see what the engine was doing when P0101 set, before you buy any parts.

Typical repair costs

RepairTypical range
Clean MAF sensor$10–$100
Replace air filter$20–$80
Replace intake boot or clamps$75–$250
Replace MAF sensor$150–$450

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0101 FAQ

No. Air leaks after the sensor and dirt on the element are common causes. Rule those out before buying a new sensor.
Quality varies. Many technicians prefer original-equipment or known-good brands because a poor-quality sensor can cause the same code.

Related codes