OBD-II trouble code · Powertrain (engine and transmission)

P0103 Mass or Volume Air Flow Circuit High Input

Your airflow sensor's signal is higher than it should be, as if far too much air were entering the engine. This usually points to a wiring short or a failing sensor.

SeverityModerate
Safe to drive?Often drivable carefully, but expect possible rough running or reduced power; get it repaired soon and stop if the engine stalls repeatedly.

My airflow sensor is shouting numbers that are way too high. It's probably a wiring short or a tired sensor, so let's check the harness.

— FRED, speaking as your car

What P0103 means

P0103 sets when the engine computer sees the MAF signal above its maximum expected value for a set time. Typical reasons include a signal wire shorted to voltage, a faulty sensor, electrical interference from nearby ignition components, or a poor ground. The computer may use a substitute value, which affects drivability. Thresholds vary by make.

Common symptoms

  • Check-engine light on
  • Rich running or fuel smell
  • Poor fuel economy
  • Rough idle
  • Hesitation
  • Possible stalling

Likely causes (most likely first)

  1. Faulty MAF sensor
  2. Signal wire shorted to voltage
  3. Poor ground at the sensor or engine
  4. Damaged or chafed wiring harness
  5. Aftermarket intake changes affecting readings
  6. Engine computer fault (rare)

What you can check yourself

  1. Inspect the MAF connector and harness for damage, especially near hot or moving parts
  2. Check engine and sensor ground connections
  3. View live MAF readings at idle; unusually high values confirm the code
  4. Check whether wiring runs close to ignition coils or spark plug wires
  5. Clean the sensor and retest
  6. Have the circuit tested with a multimeter per a wiring diagram if it persists

FRED reads freeze frame and live data, so you can see what the engine was doing when P0103 set, before you buy any parts.

Typical repair costs

RepairTypical range
Repair wiring or ground$100–$300
Replace MAF sensor$150–$450
Clean MAF sensor$10–$100
Diagnostic testing$100–$200

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0103 FAQ

Some aftermarket intakes change airflow across the sensor and can cause MAF codes. Returning to the stock intake is a useful test.
Often not. Many cases are a wiring fix or MAF sensor replacement, both of which are moderate repairs.

Related codes