OBD-II trouble code · Powertrain (engine and transmission)

P0100 Mass or Volume Air Flow Circuit Malfunction

The computer has detected a problem with the sensor that measures how much air enters your engine. Without good airflow data, the engine can run poorly and use more fuel.

SeverityModerate
Safe to drive?Usually drivable carefully, though the car may run rough, stall, or enter reduced-power mode; get it checked soon and avoid highway driving if it hesitates or stalls.

I can't trust my airflow sensor's signal right now, so I'm guessing how much fuel to use. A clean connector and sensor might fix me up!

— FRED, speaking as your car

What P0100 means

The mass airflow (MAF) sensor reports incoming air to the engine computer, which uses it to calculate fuel. P0100 is a general circuit fault: the computer saw a signal that was missing, erratic, or electrically implausible. Common culprits are wiring, connectors, power or ground supply, or the sensor itself. Some vehicles use a MAP sensor instead of a MAF, and diagnostic details vary by make.

Common symptoms

  • Check-engine light on
  • Rough idle or stalling
  • Hesitation or poor acceleration
  • Reduced fuel economy
  • Black smoke (rich) or lean stumble
  • Hard starting

Likely causes (most likely first)

  1. Damaged or corroded MAF connector or wiring
  2. Faulty MAF sensor
  3. Blown fuse or poor power/ground to the sensor
  4. Contaminated MAF sensing element
  5. Air leak in the intake boot near the sensor
  6. Engine computer fault (rare)

What you can check yourself

  1. Inspect the MAF connector for corrosion, bent pins, or a loose fit
  2. Check wiring for chafing or damage along the harness
  3. Check related fuses in the fuse box
  4. Clean the sensor with MAF cleaner and let it dry fully
  5. View live MAF readings (g/s) on your adapter; they should rise smoothly with rpm
  6. Unplug the MAF briefly with the engine idling (on many vehicles) to see if idle changes; no change can indicate a dead sensor

FRED reads freeze frame and live data, so you can see what the engine was doing when P0100 set, before you buy any parts.

Typical repair costs

RepairTypical range
Clean MAF sensor$10–$100
Repair MAF wiring or connector$100–$300
Replace MAF sensor$150–$450
Replace cracked intake boot$75–$250

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0100 FAQ

Many engines will run in a fallback mode, but poorly, with worse fuel economy and possible stalling. It is not a long-term solution.
Over-oiled aftermarket filters can contaminate the MAF element. Clean the sensor and oil filters sparingly.

Related codes