OBD-II trouble code · Powertrain (engine and transmission)

P0030 HO2S Heater Control Circuit Bank 1 Sensor 1

The heater inside the upstream oxygen sensor on bank 1 has an electrical problem. That heater helps the sensor warm up quickly so the engine can manage fuel properly.

SeverityLow
Safe to drive?Yes, it's generally safe to drive, though fuel economy and emissions may suffer and you may fail an emissions test until it's fixed.

The little heater in my front oxygen sensor on bank 1 isn't working right. I'll still drive fine, but I'm guessing at my fuel mix a bit longer every cold morning.

— FRED, speaking as your car

What P0030 means

Heated oxygen sensors (HO2S) have a small built-in heater so they reach operating temperature fast. The PCM controls and monitors that heater circuit. P0030 sets when the PCM detects a fault in the bank 1 sensor 1 heater circuit, such as an open, a short, or current outside the expected range. Sensor 1 is the upstream sensor before the catalytic converter. The most common cause is a burned-out heater element inside the sensor, but wiring, fuses, and connectors also play a role. Exact circuit design varies by make.

Common symptoms

  • Check-engine light on
  • Slightly worse fuel economy
  • Longer time in open-loop fuel control after cold starts
  • Possible emissions test failure
  • Usually no drivability symptoms

Likely causes (most likely first)

  1. Failed heater element inside the bank 1 sensor 1 oxygen sensor
  2. Damaged or melted wiring near the exhaust
  3. Corroded or loose sensor connector
  4. Blown oxygen sensor heater fuse
  5. Open or shorted heater power or control circuit
  6. Rarely, a PCM driver fault

What you can check yourself

  1. Scan for other O2 heater codes; several at once suggests a shared fuse or power issue
  2. Check the fuse for the oxygen sensor heaters
  3. Inspect the bank 1 sensor 1 wiring for contact with hot exhaust parts
  4. Unplug the sensor and inspect the connector for corrosion
  5. Measure heater resistance across the sensor's heater pins and compare to spec
  6. Check for battery voltage on the heater power wire with the key on

FRED reads freeze frame and live data, so you can see what the engine was doing when P0030 set, before you buy any parts.

Typical repair costs

RepairTypical range
Replace blown fuse and correct the cause$20–$100
Repair wiring or connector$100–$300
Replace upstream oxygen sensor (bank 1 sensor 1)$150–$400

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0030 FAQ

Often, yes, because the heater is built into the sensor and can't be replaced on its own. Check the fuse and wiring first to avoid buying a sensor you don't need.
Not usually by itself. But leaving any fuel-control issue unrepaired for a long time isn't good for the converter, so fix it reasonably soon.

Related codes