OBD-II trouble code · Powertrain (engine and transmission)
P0036 HO2S Heater Control Circuit Bank 1 Sensor 2
The heater inside the downstream oxygen sensor on bank 1 has an electrical fault. This sensor mainly checks how well the catalytic converter is working.
The heater in my rear oxygen sensor on bank 1 has quit. I'll run fine, but I can't properly grade my catalytic converter until it's fixed.
— FRED, speaking as your car
What P0036 means
Sensor 2 sits after the catalytic converter and helps the PCM monitor converter efficiency. Its built-in heater keeps it at working temperature. P0036 sets when the PCM detects a fault in the bank 1 sensor 2 heater circuit, such as an open, short, or out-of-range reading. A failed heater element inside the sensor is common, but wiring and fuses can also be responsible. Circuit design varies by make.
Common symptoms
- Check-engine light on
- Emissions readiness monitors may not complete
- Possible emissions test failure
- Usually no drivability symptoms
Likely causes (most likely first)
- Failed heater element in bank 1 sensor 2
- Damaged wiring from heat or road debris
- Corroded or loose connector
- Blown heater fuse
- Open or shorted heater circuit
- Rarely, a PCM fault
What you can check yourself
- Scan for related heater codes
- Check the oxygen sensor heater fuse
- Inspect the downstream sensor wiring under the car for damage
- Inspect the connector for corrosion
- Measure heater resistance at the sensor
- Check for power at the heater feed wire with key on
FRED reads freeze frame and live data, so you can see what the engine was doing when P0036 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace fuse and correct the cause | $20–$100 |
| Repair wiring or connector | $100–$300 |
| Replace downstream oxygen sensor (bank 1 sensor 2) | $120–$350 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.