OBD-II trouble code · Powertrain (engine and transmission)
P0050 HO2S Heater Control Circuit Bank 2 Sensor 1
The heater in the upstream oxygen sensor on bank 2 has an electrical fault. That heater helps the sensor warm up so the engine can control fuel accurately.
The heater in my front oxygen sensor on bank 2 isn't working. I'll keep you moving, but my fuel mix won't be as sharp until it's fixed.
— FRED, speaking as your car
What P0050 means
On V-type engines, bank 2 is the side without cylinder 1. Sensor 1 is the upstream oxygen sensor before the catalytic converter. P0050 sets when the PCM detects a fault in that sensor's heater circuit, such as an open, short, or abnormal current. The heater element inside the sensor commonly fails, but fuses, wiring, and connectors are also possible causes. Circuit layout varies by make.
Common symptoms
- Check-engine light on
- Slightly worse fuel economy
- Slower transition to normal fuel control after cold start
- Possible emissions test failure
- Usually no drivability problems
Likely causes (most likely first)
- Failed heater element in bank 2 sensor 1
- Heat-damaged wiring near the exhaust manifold
- Corroded or loose connector
- Blown heater fuse
- Open or shorted heater circuit
- Rarely, PCM fault
What you can check yourself
- Scan for other heater codes on other sensors
- Check the oxygen sensor heater fuse
- Find bank 2 sensor 1 and inspect its wiring for heat damage
- Inspect connector for corrosion or loose pins
- Measure heater resistance at the sensor
- Verify heater power with the key on
FRED reads freeze frame and live data, so you can see what the engine was doing when P0050 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Replace fuse and correct the cause | $20–$100 |
| Repair wiring or connector | $100–$300 |
| Replace upstream oxygen sensor (bank 2 sensor 1) | $150–$450 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.