OBD-II trouble code · Powertrain (engine and transmission)

P0018 Crankshaft Position - Camshaft Position Correlation Bank 2 Sensor A

The engine computer sees that the crankshaft and the bank 2 'A' camshaft (usually the intake cam) are out of alignment. That can be a sensor or timing component problem, including a stretched timing chain.

SeverityHigh
Safe to drive?Limit driving until it's diagnosed, because a timing chain or belt problem can lead to major engine damage; stop if you hear rattling, the engine runs rough, or the check-engine light flashes.

My bank 2 intake cam and my crankshaft aren't in sync like they should be. Could be a sensor, could be my timing chain getting loose, so let's not wait on it.

— FRED, speaking as your car

What P0018 means

The PCM continuously compares the crankshaft position signal with the camshaft position signal. P0018 sets when the bank 2 sensor A cam signal falls outside the expected correlation window with the crank signal. Possible reasons include a failing cam or crank sensor, a variable valve timing phaser stuck out of position, oil supply issues, or physical timing problems such as a stretched chain or jumped belt. Bank 2 is the side of a V engine opposite cylinder 1, and sensor A is usually the intake cam, but this varies by make.

Common symptoms

  • Check-engine light on
  • Rattle or chain noise at startup
  • Hard starting
  • Rough idle or hesitation
  • Loss of power
  • Possible stalling

Likely causes (most likely first)

  1. Stretched timing chain or worn tensioner and guides
  2. Jumped timing belt or chain
  3. Faulty bank 2 camshaft position sensor A
  4. Bank 2 intake VVT phaser or oil control solenoid fault
  5. Low or contaminated engine oil
  6. Damaged reluctor ring
  7. Faulty crankshaft position sensor

What you can check yourself

  1. Scan for related codes such as P0016 or VVT codes that point to one bank versus both
  2. Verify oil level and condition
  3. Listen for startup rattle from the timing cover area
  4. Inspect bank 2 cam sensor and crank sensor connectors and wiring
  5. Check live data for cam angle or correlation if your scanner supports it
  6. Review maintenance history for timing belt or chain service

FRED reads freeze frame and live data, so you can see what the engine was doing when P0018 set, before you buy any parts.

Typical repair costs

RepairTypical range
Oil change with correct-spec oil$50–$120
Replace camshaft position sensor$100–$300
Replace VVT solenoid or cam phaser on bank 2$200–$1,500
Timing chain or belt service with guides and tensioner$1,000–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0018 FAQ

On V6 and V8 engines, bank 2 is the cylinder bank that does not contain cylinder number 1. Your service info will show which side that is.
When both banks show correlation codes, a shared part like the timing chain, crank sensor, or oil supply becomes more likely than a single cam sensor.

Related codes