OBD-II trouble code · Powertrain (engine and transmission)
P0390 Camshaft Position Sensor B Circuit (Bank 2)
The engine computer found an electrical problem with camshaft position sensor B on bank 2. That sensor helps the computer track cam position for fuel and spark timing.
My bank 2 cam sensor B has gone quiet on me. Let's check its plug and wiring before I start acting up.
— FRED, speaking as your car
What P0390 means
On V-type engines, bank 2 is the side without cylinder 1. P0390 sets when the PCM detects a fault in the bank 2 camshaft sensor B circuit, such as a missing signal, open, short, or abnormal voltage. Sensor B is often the exhaust cam sensor, though naming varies by make. Without a good signal, the engine may use default timing and run poorly, start hard, or stall.
Common symptoms
- Check-engine light on
- Hard starting
- Stalling
- Rough idle
- Reduced power
- Poor fuel economy
Likely causes (most likely first)
- Faulty camshaft position sensor B (bank 2)
- Oil-soaked or corroded connector
- Damaged wiring
- 5-volt reference or ground issue
- Damaged tone ring
- Rarely, PCM fault
What you can check yourself
- Scan for other cam, crank, or VVT codes
- Locate bank 2 sensor B using service info
- Inspect connector for oil or corrosion
- Inspect wiring for chafing or heat damage
- Check reference voltage and ground at the connector
- Clear the code and see whether it returns
FRED reads freeze frame and live data, so you can see what the engine was doing when P0390 set, before you buy any parts.
Typical repair costs
| Repair | Typical range |
|---|---|
| Repair wiring or connector | $100–$300 |
| Replace camshaft position sensor | $100–$350 |
| Replace tone wheel (if damaged) | $300–$1,200 |
Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.