OBD-II trouble code · Powertrain (engine and transmission)

P0019 Crankshaft Position - Camshaft Position Correlation Bank 2 Sensor B

The engine computer found that the crankshaft and the bank 2 'B' camshaft (often the exhaust cam) are not lined up correctly. It can be a sensor, a cam timing adjuster, or a stretched timing chain.

SeverityHigh
Safe to drive?Drive only as needed to reach a shop, since a failing timing chain or belt can cause severe engine damage; stop if the engine rattles, runs badly, or the check-engine light flashes.

My bank 2 exhaust cam is drifting out of step with my crank. I'd love a checkup before my timing parts get any looser.

— FRED, speaking as your car

What P0019 means

The PCM uses the crankshaft and camshaft position sensors to confirm the cams stay correctly timed to the crank. P0019 sets when the bank 2 sensor B cam signal is out of its allowed relationship with the crank signal. It may come from a sensor fault, variable valve timing hardware, oil pressure or quality issues, or a mechanical timing problem like chain stretch or a jumped tooth. Bank and sensor naming vary by manufacturer, so confirm which cam is involved for your engine.

Common symptoms

  • Check-engine light on
  • Startup rattle from the timing area
  • Rough idle
  • Hard starting or long crank
  • Reduced power
  • Stalling in some cases

Likely causes (most likely first)

  1. Stretched timing chain or failing tensioner
  2. Timing jumped a tooth
  3. Faulty bank 2 camshaft position sensor B
  4. Bank 2 exhaust VVT phaser or solenoid problem
  5. Low or degraded engine oil
  6. Damaged tone ring
  7. Crankshaft position sensor fault

What you can check yourself

  1. Scan all codes and save freeze-frame data
  2. Check engine oil level and condition
  3. Listen for cold-start chain noise
  4. Inspect bank 2 exhaust cam sensor wiring and connector
  5. Compare cam timing data in live data if your scanner provides it
  6. Check if correlation codes are present on other banks or cams too

FRED reads freeze frame and live data, so you can see what the engine was doing when P0019 set, before you buy any parts.

Typical repair costs

RepairTypical range
Oil change with correct-spec oil$50–$120
Replace camshaft position sensor$100–$300
Replace exhaust VVT solenoid or phaser on bank 2$200–$1,500
Timing chain or belt replacement$1,000–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0019 FAQ

Short trips may be possible, but it isn't recommended for long. If the cause is a stretched or jumped chain or belt, continued driving risks expensive damage.
The code describes what the computer measured, a mismatch between sensor signals. The root cause can be the sensor or the parts it is measuring.

Related codes