OBD-II trouble code · Powertrain (engine and transmission)

P0021 Intake Camshaft Position Timing Over-Advanced Bank 2

The engine computer asked the bank 2 intake camshaft to be at a certain timing, but it's sitting more advanced than requested. This usually points to the variable valve timing system, oil supply, or timing chain.

SeverityModerate
Safe to drive?Generally drivable for a short time with care, but get it checked soon because the cause can involve oil supply or timing chain wear; stop if the check-engine light flashes or the engine runs very rough.

My bank 2 intake cam is running ahead of where I told it to be. Fresh oil is a good first step, then let's check that timing solenoid.

— FRED, speaking as your car

What P0021 means

On engines with variable valve timing, the PCM controls an oil control solenoid that moves a cam phaser to advance or retard the intake cam. It compares the commanded position with the actual position from the cam sensor. P0021 sets when the bank 2 intake cam is more advanced than commanded for longer than allowed, or fails to return to its rest position. Common reasons include a sticking solenoid, a phaser that won't move, low or dirty oil, or timing chain wear. Details and test procedures vary by make.

Common symptoms

  • Check-engine light on
  • Rough idle
  • Hesitation or reduced power
  • Worse fuel economy
  • Rattling at startup in some engines
  • Stalling at idle in some cases

Likely causes (most likely first)

  1. Sticking or failed bank 2 intake oil control solenoid
  2. Cam phaser stuck in the advanced position
  3. Low, dirty, or wrong-viscosity engine oil
  4. Clogged oil screen at the solenoid (on engines that have one)
  5. Stretched timing chain
  6. Cam sensor or wiring issue

What you can check yourself

  1. Check oil level and condition first
  2. Scan for related cam timing or correlation codes
  3. Inspect the bank 2 intake solenoid connector and wiring
  4. Measure solenoid resistance against the specification
  5. Use live data to compare commanded versus actual cam angle if your scanner supports it
  6. Change oil with the correct spec, clear the code, and see if it returns

FRED reads freeze frame and live data, so you can see what the engine was doing when P0021 set, before you buy any parts.

Typical repair costs

RepairTypical range
Oil and filter change$50–$120
Replace intake oil control solenoid (bank 2)$150–$450
Replace intake cam phaser (bank 2)$600–$1,800
Timing chain and related components$1,000–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0021 FAQ

It means the cam is opening the valves earlier than the computer commanded. The computer expected less advance than it measured.
Sometimes. The VVT system runs on engine oil pressure, so low or sludgy oil can cause it. If the code returns, a solenoid or phaser is more likely.

Related codes