OBD-II trouble code · Powertrain (engine and transmission)

P0012 Intake Camshaft Position Timing Over-Retarded Bank 1

The variable valve timing system has the intake camshaft further behind than the computer asked for on bank 1. This is often caused by oil problems, a sticking solenoid, or a worn cam phaser.

SeverityModerate
Safe to drive?Usually okay to drive gently in the short term after confirming oil level, but if oil is low, the engine rattles loudly, or it runs poorly, stop and get it checked to avoid engine damage.

My intake camshaft is lagging behind where I want it. Fresh oil at the right level is the first thing I'd ask for.

— FRED, speaking as your car

What P0012 means

Variable valve timing uses oil pressure and an oil control solenoid to rotate the intake camshaft. The engine computer commands a cam position and compares it with the actual position from the cam and crank sensors. P0012 sets when the bank 1 intake cam is more retarded than commanded, often noticed when the phaser fails to return or stays in its rest position. Low or dirty oil, a stuck oil control solenoid, a worn phaser, or a stretched timing chain are common causes. Bank 1 is the side with cylinder 1. Details vary by make.

Common symptoms

  • Check-engine light on
  • Rough idle
  • Reduced power, especially at low speeds
  • Worse fuel economy
  • Rattling or knocking at startup
  • Stalling in some cases

Likely causes (most likely first)

  1. Low engine oil level or pressure
  2. Dirty or wrong-viscosity oil
  3. Stuck or failing oil control solenoid
  4. Clogged oil screen
  5. Worn or stuck cam phaser
  6. Stretched timing chain

What you can check yourself

  1. Check engine oil level and condition right away
  2. Confirm the oil used matches your owner's manual
  3. Change the oil and filter if overdue or dirty
  4. Inspect the solenoid connector and wiring
  5. Remove and inspect the solenoid and screen for sludge if accessible
  6. If the code returns, listen for rattling at startup and have timing checked

FRED reads freeze frame and live data, so you can see what the engine was doing when P0012 set, before you buy any parts.

Typical repair costs

RepairTypical range
Oil and filter change$50–$120
Replace oil control solenoid$150–$450
Replace cam phaser$800–$2,000
Timing chain and guide replacement$1,000–$3,500

Typical US independent-shop ranges, parts and labor. Your price varies by vehicle, region and shop.

Get a second opinion from your own car. Plug a $15–30 OBD-II adapter into the port under your dash, open FRED and ask “Fred, what are my codes?” Get the free beta →
Which adapter?

P0012 FAQ

It means the intake valves are opening later than the computer commanded. That can reduce low-speed power and make idle rough.
A worn cam phaser or stretched timing chain can rattle for a moment at startup before oil pressure builds. A shop should inspect it.

Related codes